Operating Instructions Safety Instructions
About the controls on the air conditioner.
Fan Switch
On Heat/Cool models, the fan switch lever is located in a hole through the control panel. To reach it, you need to remove the front grille. Use a small screwdriver to change the setting. Cool only models have a rocker switch on the front of the control box.
When set at CYCLE (down) the fan cycles on and off when cooling or heating. When set at CONT (continuous, up) the fan runs all the time. The unit is shipped in the CONT setting.
Care and Cleaning
Temperature Limiting
Limiting the maximum and minimum settings prevents users from turning the control to the extreme heat or cool positions.
The normal range of the temp control is approximately 60°F to 85°F. The control range may be narrowed by the use of the temperature limiting screws located behind the control panel.
Limits | Limits |
heat | cool |
temp | temp |
Consumer Support Troubleshooting Tips Installation Instructions
Each position equals approximately 3°F.
Vent Control
The vent control is located behind the front grille on the right side of the air discharge area. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.
To open or close the vent: |
| |
1. Remove the front grille. | Open | |
2. Remove and replace the vent card to the OPEN | ||
Close | ||
(mesh end toward the back) or to the CLOSE |
| |
(mesh end toward the front) position. |
|
Air Direction
Horizontal louvers | Remove the front |
on the front grille | grille to adjust the |
let you control the | vertical louvers |
air direction up | |
and down. | direct the air left |
| or right. |
6
