Instructions
Installation for models AJES and
Read these instructions completely and carefully.
Operating Instructions Safety
6
Measure, Cut and Install the Filler Panels
AMeasure from the edge of the panel marks
(see Prepare the Window) to the inside of the window track on each side. (A and B)
Sill
|
| Window track |
|
| 133⁄8″ | 133⁄8″ |
|
A | Width of the air conditioner | B | |
Left side |
| (panel marks) | Right side |
|
|
| Mark the A and B measurements on each |
B | |
| side of the filler panel board. Cut the panels |
|
Gasket
Angle
Gasket | Panel |
| Tab |
Angle
Type C (painted screws)
Instructions Care and Cleaning
and discard the center piece. Note position |
of the notches. |
B | A |
Right side | Left side |
are(holeson the left) | (holes areontheright) |
| Filler Panels |
| Cut panels |
| and discard |
| center piece |
DInstall the panels in the window. Place the spring clips 3″ from the top and the bottom. Squeeze and push the clips to fit in the window track and the tab into the sill support.
3″
Consumer Support Troubleshooting Tips Installation
C | Put together the panel assemblies. Remove |
|
| the paper backing from the case side gasket |
|
| and attach it to the angle. Push a pencil point | Hook the tab into the |
| through the gaskets to locate the holes in | |
| sill support | |
| the angles. |
|
14