Instructions
Installation for models AJES and
Read these instructions completely and carefully.
Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety
3
Remove the Air Conditioner From the Case.
ARemove the front grille. See the Care and Cleaning section.
BFind the locking plate located on the front left side.
CRemove the screw and the locking plate to unlock the air conditioner.
Locking plate
Remove screw
DRemove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case.
Remove screw
EPull the bottom corners of the air conditioner and slide it out of the case.
FRemove the shipping pad inside the air conditioner next to the compressor.
GRemove the rear grille that is taped to the back of the case. Remove the packet of screws taped to the back of the grille. While holding the grille at a 45° angle, insert it into the clips at the top of the case and push the bottom in. Keep slight upward pressure on the grille until it fits flush with the bottom of the case.
If attaching the grille from the outside of the case use the 2 long screws.
Clips
Insert the 2 long screws on the outside
If attaching the grille on the inside of the case use the 2 short screws.
Insert the 2 short screws on the inside
Consumer
Remove shipping pad
12