Installation Instructions
Fitting into worktop
• Cut a hole in the work surface to the required size. See table for relevant dimensions.
A clearance of at least 50mm should be maintained between the cutout and any rear or side wall.
• The worktop must be of
• Protecting the
The types of chipboard used for work sur- faces swell relatively quickly in contact with humidity.
Apply a special varnish or adhesive to the cut edge to protect it from steam or con- densation which may form under the work surface under the hob.
This hob can be installed conventionally (glass above the work top) or recessed into the work top for a flush fit.
Conventional Installation
Apply the self adhesive seal to the underside edges of the hob glass. For best results, the seal should be adhered along each side in turn, as close to the edge as possible, and trimmed at each corner, taking care to ensure a neat join.
Place the hob in the aperture, checking the hob glass is covering the work top along all four sides. Set the front edge of the appliance parallel with the front of the work top. Locate and attach the securing clamps to the front and rear underside of the hob, using the
23