Glen Dimplex Home Appliances Ltd PBI60R Installation above an oven, Installation Instructions

Installation Instructions

Installation above an oven

Refer to the manufacturer’s instructions for clearances above the oven.

We recommend a 9mm gap between the bottom of the hob and appliance, should the work surface be less than 38mm deep.

In the case of a pyrolytic oven

If installing the hob above a pyrolytic oven, additional provision for air circulation / ventilation may be required. Due to the excessive temperatures attained during pyroly- sis, using the hob at the same time may cause the thermal safety device within the hob to operate.

50mm

	min	5mm min
9mm		air gap

Clearances and dimensions - requirements
1.	No shelf or overhang of combustible material should
2.	be closer than 650mm above the hob.
	There must be a minimum clearance of 50mm
	between the edges of the hob and any side walls;
	this clearance must be maintained up to 420mm				rear wall
3.	above the worktop.
	There must be a minimum clearance of 50mm			53mm min
	between the rear edge of the hob and the rear		wall min	550mm
	wall. This clearance must be maintained up to
	650mm above the worktop.		53mm		480
4.	When installing an extractor hood above the hob,
	refer to their Manufacturer’s instructions.		side		nso
				cutout
	600 hob - 600mm
	piiP	PfPpii
	riiP	PfPrii

wall unit					wall unit
			This area must
			bePkeptPclear of
			P P
420mm		40mm	combustible	40mm
			materials
nli			P		650mm above level
						of pan supports
						oi
	worktop					P P
						P

22