Echo PAS-2100, 261, 231, SRM-2100SB, 2400, 260SB, 225VPB, 211SB Equipment, Avoid Hot Surfaces

Avoid Hot Surfaces

• During operation, the drive shaft housing and attachment bearing housing may become very hot, too hot to touch. Avoid contact during and immediately after operation.

Equipment

Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non approved ECHO product.

•Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

•Inspect shield for damage and ensure that the cut-off knife is securely in place. Replace if either is damaged or missing.

•Check that the cutting attachment is firmly attached and in safe operating condition.

Note: ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO.

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings.

◆ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.

◆DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

◆NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.

© 2/2014 ECHO Inc.