Echo GT-230 specifications Assembly, Plastic Shield Installaion, Nylon Line Head Installation

Page 13

GT-230ASSEMBLY

ASSEMBLY

Plastic Shield Installaion

Parts Required:	Nylon Trimmer Head, Plastic Shield
	Assembly.

Cut-off knife on debris shield has sharp edges. Avoid contact when installing or removing line head.

Wear Gloves or personal injury may result:

◆Cutoff knife is sharp.

◆Gearcase and surrounding area may be hot.

1.Remove wing nut (A), washer (B), and bolt (C).

2.Snap the shield over the bearing housing.

3.Install bolt (C), washer (B), and wing nut (A).

Nylon Line Head Installation

1.Remove plastic threaded shaft sleeve from threaded PTO shaft.

2.Align locating hole in upper plate with hole in bearing housing and insert 5 mm (3/16 in.) diameter locking tool (D).

3.Thread cutting attachment onto shaft clockwise until head is tight.

B

AC

D

Remember to remove the locking tool.

Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife.

X7702094205

13

© 09/2013 ECHO Inc.

Image 13

Contents Operator’s Manual Table of Contents Servicing Information IntroductionAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information Personal Condition and Safety Equipment International SymbolsPhysical Condition Eye ProtectionHearing Protection Breathing ProtectionProper Clothing Hot Humid WeatherRead the Manuals Repetitive Stress InjuriesClear the Work Area Keep a Firm GripKeep a Solid Stance EquipmentAvoid Hot Surfaces EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Plastic Shield Installaion AssemblyNylon Line Head Installation Remove Nylon Line Head To Advance Trimmer LineSupport Handle Fuel OperationFuel Requirements Handling FuelAfter use Purge Bulb Starting Cold EngineStopping Engine Starting Warm EngineMaintenance Intervals MaintenanceSkill Levels Fuel Filter Air FilterCooling System Spark PlugSpark Arrestor Screen Exhaust SystemExhaust Port Cleaning Carburetor AdjustmentEngine Break-In High Altitude OperationLubrication Nylon Line Head Disassembly InstructionsTrimmer head is now fully loaded and ready for operation Nylon Line ReplacementEngine Problem Troubleshooting Chart TroubleshootingLong Term Storage Over 30 Days StorageModel SpecificationsOWNER’S Responsibility Warranty StatementsWarranty Statements GT-230 ECHO, Incorporated