Echo GT-230 specifications To Advance Trimmer Line, Remove Nylon Line Head, Support Handle

ASSEMBLY GT-230

To Advance Trimmer Line

See Maintenance Section for nylon line replacement.

Note: To advance trimmer line, tap trimmer head against the ground while the head is turning at normal operating speed.

Remove Nylon Line Head

Note: Do not disassemble nylon line head.

1.Align locating hole in upper plate with hole in bearing housing and insert 5 mm (3/16 in.) diameter locking tool (D).

2.Remove line head by turning it counter clockwise until head is completely off of shaft.

3.Remove locking tool (D).

Support Handle

Note: Label shows minimum spacing for support handle location.

Note: Support handle is pre-installed. Re-positioning and tightening is all that is required.

1.Position support handle (E) in comfortable operating position and tighten wing nut (F). The cutting attachment should be 5-7.5 cm (2-3 in.) above the ground and as level as possible.

D

E

F

14 X7702094205

© 09/2013 ECHO Inc.