Echo GT-230 specifications Long Term Storage Over 30 Days

Page 27

GT-230

STORAGE

 

 

STORAGE

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

Long Term Storage (Over 30 Days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Tighten all the screws and nuts.

6.Drain fuel tank completely. Press purge bulb 6-7 times to remove remaining fuel from carburetor then drain the tank again. Close choke, start and run the engine until it stops due to lack of fuel.

7.

a.Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

b.Pull the recoil starter handle 2-3 times to distribute the oil inside the engine.

c.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

X7702094205

27

© 09/2013 ECHO Inc.

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Operator’s Manual Table of Contents Servicing Information IntroductionSafety Additional or Replacement ManualsManual Safety Symbols and Important Information Eye Protection International SymbolsPersonal Condition and Safety Equipment Physical ConditionHot Humid Weather Breathing ProtectionHearing Protection Proper ClothingKeep a Firm Grip Repetitive Stress InjuriesRead the Manuals Clear the Work AreaEquipment Keep a Solid StanceAvoid Hot Surfaces Emission Control Exhaust & Evaporative EPA 2010 and Later and/or C.A.R.B. TierProduct Emission Durability Emission Compliance Period Description Description Contents Assembly Plastic Shield InstallaionNylon Line Head Installation To Advance Trimmer Line Remove Nylon Line HeadSupport Handle Handling Fuel OperationFuel Fuel RequirementsAfter use Purge Bulb Starting Cold EngineStopping Engine Starting Warm EngineMaintenance Maintenance IntervalsSkill Levels Fuel Filter Air FilterCooling System Spark PlugSpark Arrestor Screen Exhaust SystemHigh Altitude Operation Carburetor AdjustmentExhaust Port Cleaning Engine Break-InLubrication Nylon Line Head Disassembly InstructionsTrimmer head is now fully loaded and ready for operation Nylon Line ReplacementEngine Problem Troubleshooting Chart TroubleshootingLong Term Storage Over 30 Days StorageModel SpecificationsOWNER’S Responsibility Warranty StatementsWarranty Statements GT-230 ECHO, Incorporated
Top Page Image Contents