Echo SRM - 225U manual Fuel Requirements

Page 17

Grass Trimmer/Brush Cutter 17

Operator's Manual

fuel

NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor performance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage section of this manual.

WARNING

Alternative fuels, such as E-15 (15% ethanol), E-85 (85% ethanol) or any fuels not meeting ECHO requirements are NOT approved for use in ECHO 2-stroke gasoline engines. Use of alternative fuels may cause performance problems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including, but not limited to, improper clutch engagement. Alternative fuels may also cause premature deterioration of fuel lines, gaskets, carburetors and other engine components.

Fuel Requirements

Gasoline - Use 89 Octane [R+M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 10% Ethanol (grain alcohol) or 15% MTBE (methyl tertiary-butyl ether). Gasoline containing methanol (wood alco- hol) is NOT approved.

Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FC/FD Standards must be used. Echo brand premium Power Blend X TM Universal 2-Stroke Oil meets these standards. Engine problems due to inadequate lubrication caused by failure to use an ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FC/FD certified oil, such as Echo premium Power Blend X TM, will void the two-stroke engine warranty.

IMPORTANT

Echo premium Power Blend X TM Universal 2-Stroke Oil may be mixed at 50:1 ratio for application in all Echo engines sold in the past regardless of ratio specified in those manuals.

Handling Fuel

DANGER

Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.

Use an approved fuel container.

DO NOT smoke near fuel.

DO NOT allow flames or sparks near fuel.

Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.

NEVER refuel a unit when the engine is HOT or RUNNING!

DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.

DO NOT overfill fuel tank. Wipe up spills immediately.

Securely tighten fuel tank cap and close fuel container after refueling.

Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.

Move at least 3m (10 ft.) from refueling location before starting the engine.

Image 17
Contents Grass Trimmer/Brush Cutter Table of Contents Safety manualIntroduction Operators manualPersonal condition and safety equipment Safety Manual safety symbols and important informationInternational symbols Eye Protection Physical ConditionHand Protection Hearing ProtectionRead the Manuals Repetitive Stress InjuriesClear the Work Area Keep a Firm GripEPA 2010 and Later and/or C.A.R.B. Tier EquipmentEmission Control exhaust & evaporative Shaft Decal DescriptionPage Contents Nylon line operation Assembly Plastic shield installationNylon line head installation Install Metal Shield Blade installationTo advance trimmer line Remove nylon line headInstall Blade Throttle linkage and ignition leads Handle installationBalance and adjust unit Blade selection OperationPage Fuel Requirements FuelMixing Instructions Purge Bulb Starting cold engineStarting warm engine Skill levels MaintenanceStopping engine Level USE Hours Maintenance intervalsFuel filter Air filterCooling system Spark plugSpark Arrestor Screen Exhaust systemExhaust Port Cleaning High Altitude Operation Carburetor adjustmentEngine Break-In Drive Shaft Gear HousingLubrication Nylon line replacement Page Sharpening metal blades Engine Problem Troubleshooting Chart TroubleshootingLong Term Storage over 30 days StorageModel SRM-225U SpecificationsExceptions Warranty Statements99922201032 12/03/09 01/2010 Page Grass Trimmer/Brush Cutter 39 Operators Manual Warranty registration Additional or replacement manuals ServiceServicing Information parts/serial number Echo consumer product support