Echo SRM - 225U manual Assembly Plastic shield installation, Nylon line head installation

Page 10

10

Assembly

plastic shield installation

(Nylon line operation)

Tools Required: Torx T27 L-Wrench, Locking Tool

Parts Required: Plastic Debris Shield, Shield Plate, three (3) 5 x 16 mm screws.

WARNING

The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic or metal blades, or serious injury may result.

1.Align hole in upper plate (A) with notch in gear housing (B), and insert locking tool to prevent splined shaft from turning. Arrow on gear housing flange points to notch location.

2.Remove cotter pin (C), L.H. blade nut (D), lower plate (E), and upper plate (A) from PTO shaft (F). Turn blade nut clockwise to remove.

3.Remove locking tool (G). Retain lower plate (E), blade nut, and cotter pin (C) for future use with blade conversions.

4.Align plastic debris shield (H) with the drive shaft, and install on the bottom of the gear housing flange.

5.Place shield plate (I) on shield, align holes and install three (3) screws.

6.Replace upper plate (A) on PTO shaft (F).

B

A

F

E D C

H

A

I

nylon line head installation

Tools Required: Locking Tool, 17x19 mm Wrench

Parts Required: Nylon Line Head.

Caution

Wear Gloves or personal injury may result:

Cutoff knife is sharp.

Gearcase and surrounding area may be hot.

1.Make sure plastic debris shield (H) is properly aligned, and upper plate (A) is installed on splined PTO shaft (F).

2.Align hole in upper plate (A) with notch in gear housing (B), and insert locking tool (G) to prevent splined shaft from turning.

3.Thread line head (J) onto PTO shaft by turning it counter-clock- wise until head is tight against upper plate (A).

4.Remove locking tool (G).

IMPORTANT

Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife. Using nylon line heads with metal debris shield can result in trimmer damage, caused by operation with excessive line length.

G

F

A

G

J

Image 10
Contents Grass Trimmer/Brush Cutter Introduction Safety manualTable of Contents Operators manualInternational symbols Safety Manual safety symbols and important informationPersonal condition and safety equipment Hand Protection Physical ConditionEye Protection Hearing ProtectionClear the Work Area Repetitive Stress InjuriesRead the Manuals Keep a Firm GripEmission Control exhaust & evaporative EquipmentEPA 2010 and Later and/or C.A.R.B. Tier Description Shaft DecalPage Contents Nylon line head installation Assembly Plastic shield installationNylon line operation To advance trimmer line Blade installationInstall Metal Shield Remove nylon line headInstall Blade Handle installation Throttle linkage and ignition leadsBalance and adjust unit Operation Blade selectionPage Fuel Fuel RequirementsMixing Instructions Starting cold engine Purge BulbStarting warm engine Stopping engine MaintenanceSkill levels Maintenance intervals Level USE HoursAir filter Fuel filterSpark plug Cooling systemExhaust system Spark Arrestor ScreenExhaust Port Cleaning Engine Break-In Carburetor adjustmentHigh Altitude Operation Lubrication Gear HousingDrive Shaft Nylon line replacement Page Sharpening metal blades Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage over 30 daysSpecifications Model SRM-225UWarranty Statements Exceptions99922201032 12/03/09 01/2010 Page Grass Trimmer/Brush Cutter 39 Operators Manual Servicing Information parts/serial number ServiceWarranty registration Additional or replacement manuals Echo consumer product support