Echo SRM - 225U manual Equipment, Emission Control exhaust & evaporative

Page 6

6

equipment

WARNING

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment com- bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and safety manual.

Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

Inspect shield for damage and ensure that the cut-off knife is securely in place. Replace if either is damaged or miss- ing.

Check that the cutting attachment is firmly attached and in safe operating condition.

Check that front loop handle and shoulder strap/ or shoulder/waist harness are adjusted for safe, comfortable opera- tion. See Assembly Section for proper adjustment.

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings.

ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.

WARNINg

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found, do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho- rized servicing dealer before using.

Emission Control (exhaust & evaporative)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to California models only.

An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by engine FAMILY).

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 300 hour emission durability compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.

Image 6
Contents Grass Trimmer/Brush Cutter Introduction Safety manualTable of Contents Operators manualSafety Manual safety symbols and important information International symbolsPersonal condition and safety equipment Hand Protection Physical ConditionEye Protection Hearing ProtectionClear the Work Area Repetitive Stress InjuriesRead the Manuals Keep a Firm GripEquipment Emission Control exhaust & evaporativeEPA 2010 and Later and/or C.A.R.B. Tier Description Shaft DecalPage Contents Assembly Plastic shield installation Nylon line head installationNylon line operation To advance trimmer line Blade installationInstall Metal Shield Remove nylon line headInstall Blade Handle installation Throttle linkage and ignition leadsBalance and adjust unit Operation Blade selectionPage Fuel Fuel RequirementsMixing Instructions Starting cold engine Purge BulbStarting warm engine Maintenance Stopping engineSkill levels Maintenance intervals Level USE HoursAir filter Fuel filterSpark plug Cooling systemExhaust system Spark Arrestor ScreenExhaust Port Cleaning Carburetor adjustment Engine Break-InHigh Altitude Operation Gear Housing LubricationDrive Shaft Nylon line replacement Page Sharpening metal blades Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage over 30 daysSpecifications Model SRM-225UWarranty Statements Exceptions99922201032 12/03/09 01/2010 Page Grass Trimmer/Brush Cutter 39 Operators Manual Servicing Information parts/serial number ServiceWarranty registration Additional or replacement manuals Echo consumer product support