‹Battery Indicator, ‹Onscreen Reference Manual

Unable to automatically enter	z If a peripheral is connected to the computer, disconnect the device
standby or hibernation mode	z When the internal LCD is closed, the computer may not enter standby or
	hibernation mode. In order to activate standby or hibernation automatically
	while using the computer with the internal LCD closed, set [Touch Pad] to
	[Disable] in the [Main] menu of the Setup Utility.
	z If there is a disk in the DVD-ROM & CD-R/RW drive that has been formatted
	using B’s CLiP, the computer will not enter standby or hibernation mode.
	Remove the disk.
The computer does not resume	z Did you disconnect the AC adaptor or the battery pack while the computer
	was in standby mode? If the computer's power supply is disconnected while
	the computer is in standby mode all unsaved data will be lost.
	z Did you slide the power switch and hold it for four seconds or more? If so,
	the power will be turned off forcibly. In this case, all unsaved data will be
	lost.

Battery Indicator

The red indicator is lit	z The battery level is very low (the charge is approx. 9% or less).
	z Connect the AC adaptor. You can use the computer when the indicator light
	is orange. If you do not have an AC adaptor, save your data and power off
	your computer. After replacing the battery pack with a fully charged one,
	turn your computer on again.
The red indicator blinks	z Quickly save your data and power off your computer. Disconnect the AC
	adaptor and remove the battery pack, then connect them again. If the prob-
	lem persists, contact your technical support office. The battery pack or
	charging circuit may be defective.
The orange indicator blinks	z Battery cannot be recharged temporarily because the internal temperature
	of the battery pack is beyond the acceptable temperature range for recharg-
	ing. Once the allowable range requirement is satisfied, charging begins
	automatically. Your computer can be used normally in this state.

Troubleshooting

The Reference Manual is not dis- played

zIs Adobe Reader installed?

If you have uninstalled Adobe Reader, install using the following proce- dures.

ALog on to Windows with the administrator authority.

BClick [start] - [Run], input [c:\util\reader\AdbeRdr60_enu_full.exe], then click [OK].

Install Adobe Reader by following the instructions on the screen.

CUpdate Adobe Reader to its latest version.

If your computer is connected to the Internet, start up Adobe Reader and click [Help] - [Update].

If your computer is not connected to the Internet, click [start] - [Run], input [c:\util\reader\Acro-Reader_6.0.2_Update.exe], then click [OK].

If the DVD-ROM & CD-R/RW drive	z Is the disk bent or labeled?
vibrates excessively or is noisy	z Check to see if the disk is inserted correctly, and it is in good condition. If the
	disk is good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in the
	Setup Utility (Î page 33).
	z When writing to CD-R/RW using B's Recorder, you can minimize vibration
	while writing by setting the writing speed at [8x] or less.