Hard Disk Backup Function
zTo disable the hard disk backup function
Perform the reinstallation procedure. All data in the backup area and the hard disk will be erased.
Conduct steps
•When [1] is selected, the hard disk backup function can be disabled.
•When [2] is selected, the hard disk backup function can be disabled, but in this case, because the hard disk has been divided into partitions, the hard disk backup function cannot be
•When [3] is selected, the hard disk backup function cannot be disabled.
<When the hard disk backup function has been enabled>
If you select [3] in step 3 C (Î page 59) and execute reinstallation, the drive name for the second partition (data partition) may be switched with that of the SD Memory Card. You can still use the drives after the names have been switched, but you can also return the drive names to their original state using the following procedures.
(The following procedure assumes that before reinstallation, the second partition (data partition) was Drive D:, and the SD Memory Card was Drive E:)
ADisable the drive name for the second partition (data partition).
(1)Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools] and double click [Computer Management].
(2)Click [Disk Management] from [Storage].
(3)Right click on the partition for which [E:] is displayed and click [Change Drive Letter and Paths...].
(4)Click [Remove].
(5)At the confirmation message, click [Yes].
BChange the SD memory card drive name to [E:].
Use the SD drive name change tool to change the SD Memory Card to the E: drive. (Î "Chapter 4: SD Memory Card/MultiMedia Card" in onscreen Reference Manual).
CSet the drive name for the second partition (data partition) as [D:].
(1)Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools] and double click [Computer Management].
(2)Click [Disk Management] from [Storage].
(3)Right click on the partition for which the drive name is not displayed, and click [Change Drive Letter and Paths...].
(4)Click [Add...], assign [D:] as the drive letter, and click [OK].
Important Information
68
