CLEAN | UNDER | ENGINE COVER | Be | |
Clean under engine cover before each | 1. | |||
2. | ||||
use, or more frequently in heavy cutting | ||||
3. | ||||
or dirty conditions. Engine cover screen | ||||
| ||||
and engine air intake screen must be | 4. | |||
kept free of dirt and chaff to prevent | ||||
| ||||
engine | damage | from overheating. | 5. | |
|
|
| ||
| Knob | Engine |
| |
|
| cover |
|
Engine cover screen
Starter rope
Air intake
CAUTION: Before performing any service and adjustments:
1.Stop engine.
2.Make sure the rotating lines and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
sure engine is cool before cleaning. Unscrew knob on top of cover.
Lift cover up and away from engine. Clean cover and cover screen
thoroughly.
Clean top of engine and air intake screen.
Replace engine cover and tighten knob securely. Be sure the front tabs of engine cover are located in the slots in engine housing.
Threaded
screen
Housing slots
Upper
//
TRIMMER
TO ADJUST TRIMMING HEIGHT
See "TO ADJUSTTRIMMING HEIGHT" in the Operation section of this manual.
I!
Handle knob
TO ADJUST HANDLE
The upper handle may be adjusted to different height positions.
•Loosen handle knob only enough to allow the upper handle to pivot to the desired position.
•Tighten handle knob securely.
NOTE: The handle knob and bolt may be reversed for left handed operation.
12