TO REMOVE/REPLACE TRIMMER HEAD DRIVE BELT
1.Remove screw at front of chassis cover.
2.Lift cover up and away from trimmer.
3.Turn trimmer on its side with carbure- tor and fuel cap up.
4.Remove belt from engine pulley on crankshaft,
5.Remove belt from trimmer head pulley.
6.Remove idler assembly from chassis and remove belt and idler from
trimmer.
7.Remove belt from idler assembly by removing bottom belt keeper and idler pulleys.
8.Assemble new belt, idler pulleys and bottom belt keeper to idler bracket. Tighten pulley bolts securely.
NOTE: Be sure belt is inside top belt keeper on idler assembly.
9.Position belt and idler assembly in trimmer and assemble idler to chassis. Tighten securely.
10.Install belt around trimmer head pulley and engine pulley,
11.Replace chassis cover and tighten screw securely.
Always use Craftsman replacement parts to assure proper fit and long life.
Screw
Chassis cover
Engine pulley
Nut
Chassis_.
Belt
Top belt | "" |
keeper | Bolt |
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your unit to a Sears or other qualified service center for repair and/or adjustment.
CARBURETOR
Your carburetor has a nonadjustable fixed main jet for mixture control. If your engine does not operate properly due to sus- pected carburetor problems, take your unit to a Sears or other qualified service center for repair and/or adjustment. IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the
Idler
Spacerbracket
Idler
Flatidler
_Bottom belt keeper
Flat idler
. Trimmer head pulley