Brother LX-570 warranty How to Change the Cartridge, How to Change the Cutter, Unsnap the cutter

Page 2

How to Change the Cartridge

Remove the cartridge:

Insert a cartridge:

1 Lift up the latch to open the top cover. Then

2 Open the top cover and lower

grasp the cartridge in one hand, hold the

the cartridge in with the label up,

LX-570 with the other, and lift the cartridge

facing the feed deck.

up and out.

 

 

As you lower the cartridge, be

 

sure that the backing material

 

fits underneath the cutter bar at

 

the exit area.

 

Close the top cover by gently

 

pushing down until it clicks and

 

is fully seated.

Guide the backing material under the cutter bar into the exit area.

Notes: When placing a partially-used cartridge back in the machine, be sure the material does not adhere to the cartridge itself.

When removing a used cartridge whose material has wrapped around the rollers, remove the cartridge and pull the material from the rollers.

The cartridge is properly installed when the label is flush with the feed deck.

Close the top cover before using.

How to Change the Cutter

1 Unsnap the cutter:

Place your thumb underneath the back of the

1

cutter knob and your index finger on the cutter bar. Lift up with your thumb to unsnap the cutter from the cutter bar.

Blade is at this end and fits into

2Snap the new cutter into place:

At any point on the cutter bar, place the front of the cutter into the groove on the cutter bar so the blade fits into it. Then rotate the cutter back and snap down.

Front of cutter

Back of cutter

Groove in cutter bar

Blade is at front of cutter. Avoid touching the blade.

a groove on the cutter bar. Always avoid touching the blade.

When installed properly, the cutter slides

back and forth on the cutter bar.

US5022001

Image 2
Contents Cutter bar How to Use the LX-570About the LX-570 KnobRemove the cartridge Insert a cartridge How to Change the CartridgeHow to Change the Cutter Unsnap the cutterPage To clean the rollers ProblemSolutionTo clean the cutter area Page Page Page