Cleaning and maintenance After every shave, remove the foil frame 7 (d) and tap out lightly. Brush out the cutter block 6 with the clean- ing brush 9 (e). Do not clean the shaving foil with the cleaning brush 9 to avoid damaging it. Approximately every four weeks clean the space between the longhair trimmer 5 and the shaver with the cleaning brush 9.
Clean the cutter block 6 with Braun cleaning spray to maintain your shav- er’s top shaving performance and to keep it hygienic. After every cleaning replace the foil protection cap 8 on the foil frame 7.
Changing the shaving parts
The shaving foil frame 7 should be
held at the two grooved surfaces and pulled off (d).
The cutter block 6 can be removed (e.g. for cleaning) by turning it at right angles to the shaver and lifting it off (f). To replace the cutter block, snap it onto the holding studs (g). Replace the new foil frame in the right direction (d) until it locks in place.
Important
Buy only original Braun spare parts, especially when replacing the mains lead or the shaving foil frame 7.
When buying a new shaving foil
frame look for the brand and the correct identification number «596» (h).
When looking to purchase a new Braun foil frame, ensure that you buy the right colour: a grey or black coloured frame.
Only this way you can be assured of a safe, close and efficient shave.
Parts for car or boat
When recharging your shaver in a car or boat use only the special Braun charging cord (No.
Subject to change without notice.
This product conforms to the
6