Meade TE256W Time and Calender, Clock Alarms, Setting the Weekday W and Single DAY S Alarms

Page 11

TIME AND CALENDER

Press and hold MODE button until the day of week language abbreviation “ENG” will flash

Press the UP (? ) or DOWN (? ) selecting the day of the week in English, German, French, Italian, Spanish, Dutch or Swedish.

After the language of weekday is set, press MODE button to confirm and move to the next parameter (year)

Continue setting the year, month, day, time format (12 or 24 hours), local hour and minutes, using the same technique

After programming is complete the display will return to the default hour and minutes with seconds display.

CLOCK ALARMS

There are two time alarms – Weekday alarm (W) and Single day alarm(S) - and one Ice Warning Alarm (PRE-AL).

If Weekday (W) alarm is activated, it will sound at the set time and the alarm icon will flash Mondays through Fridays

If Single (S) day alarm is activated, it will sound at the set time and the alarm icon will flash only for this specific day and will not activate on subsequent days

If Ice Warning Alarm ( PRE-AL)is activated, in will sound at the set time and alarm icon will flash once the remote temperature for Channel One (1) will reach 32°F(0°C) and below

NOTE: Ice Warning Alarm can be set only if one or both - Weekday or Single alarm - are programmed.

SETTING THE WEEKDAY (W) AND SINGLE DAY (S) ALARMS

Press ALARM button once to enter into the alarms setting mode. The default alarm is a Weekday alarm (W). The abbreviation “OFF” with a letter “W” next to it will be displayed, if the alarm has not been set previously

Press and hold ALARM button for two seconds. The hour digit will flash

Adjust the hour using UP ( ? ) or DOWN ( ? ) buttons

Press ALARM button again. The minute digits will flash

Adjust the minutes using UP (? ) or DOWN (? ) buttons

Press ALARM button again to confirm and the weekday alarm time will be set

Set Single (S) day alarm if desired in the same manner

SETTING THE ICE WARNING ALARM (PRE-AL)

If Weekday (W) or Single day (S) alarm is set, the Ice Warning Alarm (Pre-AL) can be programmed.

Press ALARM button once to enter into the Ice Warning Alarm setting mode. The abbreviation OFF with a PRE-ALnext to it will be displayed.

Press and hold ALARM button for two seconds. The number 30 will flash, meaning that if selected, the alarm will sound 30 minutes earlier than the Weekday or Single alarm.

Select the desired Ice Warning Alarm interval in 15 minutes increments between 15 and 90 minutes, using UP (? ) or DOWN (? )buttons

Press ALARM button to confirm and exit from the alarm setting mode.

ACTIVATING/ DEACTIVATING ALARMS

Press ALARM button to enter into the desired alarm mode.

Press UP ( ? ) to activate alarm and the corresponding icons W, S or PRE-ALwill be displayed.

Press DOWN ( ? ) to deactivate alarm until “OFF” is displayed.

11

Image 11
Contents Page Introduction Before YOU Begin InstallationMounting FeaturesBattery Installation Main Unit PlacementTemperature and Humidity OperationFront Rear Table Stand Search for Remote Sensors Getting Started TEMPERATURE/ Humidity WindowRemote Sensors Status IconStatusActivating or Deactivating Temperature Alarms Viewing Remote Channel Temperature and HumidityProgramming Temperature in Celsius or Fahrenheit Setting Temperature AlarmIcon Manual SettingsClock Window Wwvb Radio Controlled TimeACTIVATING/ Deactivating Alarms Clock AlarmsSetting the Weekday W and Single DAY S Alarms Setting the ICE Warning Alarm PRE-ALMaintanance CleaningTroubleshooting PrecautionsMain Unit Indoor Temperature SpecificationsStandard Warranty Information Battery Safety InstructionsMeade Instruments Corp