Meade TE256W user manual Features, Battery Installation, Mounting

Page 4

REMOTE TEMPERATURE AND HUMIDITY SENSOR (TS21)

FEATURES

Remote data transmission to the main unit via 433 MHz frequency

Single transmission channel

Case can be wall mounted using accessory hanger

A. BATTERY COMPARTMENT

A

B

• Holds two AAA-size batteries

B. WALL-MOUNT RECESSED HOLE

• Mounts the remote sensor on the wall

BATTERY INSTALLATION

NOTE: When the temperature falls below freezing point 32F° (0C°), battery voltage will drop which may result in reduced the transmission range. For optimum performance in cold weather conditions, we recommend using lithium batteries.

NOTE: Install the batteries before mounting the remote sensor.

Remove the screws from the battery compartment with a small Phillips screwdriver (not included).

Install 2 “AAA” size batteries (not included) matching the polarities shown in the battery compartment.

Replace the battery compartment door and secure the screws.

Secure the remote sensor in the desired location.

MOUNTING

The remote sensor can be mounted either horizontally or vertically.

Use a screw, rather than a nail, to securely mount the sensor.

4

Image 4
Contents Page Introduction Installation Before YOU BeginBattery Installation FeaturesMounting Placement Temperature and HumidityOperation Main UnitFront Rear Table Stand Getting Started TEMPERATURE/ Humidity Window Remote Sensors StatusIconStatus Search for Remote SensorsViewing Remote Channel Temperature and Humidity Programming Temperature in Celsius or FahrenheitSetting Temperature Alarm Activating or Deactivating Temperature AlarmsManual Settings Clock WindowWwvb Radio Controlled Time IconClock Alarms Setting the Weekday W and Single DAY S AlarmsSetting the ICE Warning Alarm PRE-AL ACTIVATING/ Deactivating AlarmsCleaning TroubleshootingPrecautions MaintananceSpecifications Main Unit Indoor TemperatureBattery Safety Instructions Standard Warranty InformationMeade Instruments Corp