Meade TE256W Viewing Remote Channel Temperature and Humidity, Setting Temperature Alarm, Com, Wet

Page 9

VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY

Static Display:

• Press the CHANNEL button to select measurements from different remote sensors, each is MODE to a unique channel 1, 2 or 3.

Channel Auto-Scan Display:

To enable an automatic scan of all channels, press and hold CHANNEL, until the icon is displayed. The measurements from each remote channel will be alternately displayed with a

5 seconds viewing.

NOTE: the channel auto-scan feature can be activated only if there are more than one remote sensors operating and are set to different channels.

PROGRAMMING TEMPERATURE IN CELSIUS OR FAHRENHEIT

Press and hold MODE button for 3 seconds to toggle the temperature unit in Celsius (ºC) or Fahrenheit (ºF).

SETTING TEMPERATURE ALARM

Press down button to select temperature display.

Press ALARM button selecting the desired alarm, the upper temperature alert with icon (if disabled, displays OFF), or lower temperature alert with icon (if disabled, displays OFF).

Press and hold ALARM button until the temperature digits flashing.

Adjust the temperature digits using the UP (? ) or DOWN (? ). Press and hold either button for fast digits advance

Press the ALARM to confirm selection and return to the temperature alarm selection screen

ACTIVATING OR DEACTIVATING TEMPERATURE ALARMS

Once the above alerts are displayed, press the UP (? ) or DOWN (? ) to enable or disable the corresponding alert.

VIEWING MAXIMUM AND MINIMUM READINNGS

Press the MEM button recalling:

Current temperature and humidity

Minimum temperature and humidity

Maximum temperature and humidity

RESETTING TEMPERATURE MEMORIES

Press and hold MEM button for 3 seconds to clear all channel memories.

COMFORT LEVEL INDICATION

The main unit is capable of detecting and displaying the current indoor comfort levels of surrounding environment. The comfort level based on the combination of the current indoor temperature and humidity readings. The following comfort levels may be displayed: COMFORT (comfortable); WET (wet) and DRY (dry)

Indicator

Temperature

Humidity

Shows current

displayed

Range

Range

condition

 

 

 

 

COM

20°C to 25°C

40%RH-

Ideal relative humidity

(68°F to 77°F)

70%RH

and temperature

 

 

 

 

WET

-5°C to 50°C

OVER

Contains excess

(23°F to122°F)

70%RH

moisture

 

 

 

 

 

DRY

5°C to 50°C

BELOW

Contains inadequate

(23°F to122°F)

40%RH

moisture

 

 

 

 

9

Image 9
Contents Page Introduction Before YOU Begin InstallationFeatures Battery InstallationMounting Temperature and Humidity PlacementOperation Main UnitFront Rear Table Stand Remote Sensors Status Getting Started TEMPERATURE/ Humidity WindowIconStatus Search for Remote SensorsProgramming Temperature in Celsius or Fahrenheit Viewing Remote Channel Temperature and HumiditySetting Temperature Alarm Activating or Deactivating Temperature AlarmsClock Window Manual SettingsWwvb Radio Controlled Time IconSetting the Weekday W and Single DAY S Alarms Clock AlarmsSetting the ICE Warning Alarm PRE-AL ACTIVATING/ Deactivating AlarmsTroubleshooting CleaningPrecautions MaintananceMain Unit Indoor Temperature SpecificationsStandard Warranty Information Battery Safety InstructionsMeade Instruments Corp