Meade TE636W Remote Sensors Status, Search for Remote Sensors, Setting Temperature Alarm

Page 11

REMOTE SENSORS STATUS

The wave icon above the current channel icon shows the connection status of the corresponding remote sensor:

Icon

Status

Searching for the signals from the remote sensor

Corresponding remote sensor signal received successfully

No signals received for over 1 hour

SEARCH FOR REMOTE SENSORS

The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN (? ) button.

OPERATION

To select the indoor/ outdoor temperature mode, press UP (? ) or DOWN (? ) until the IN icon flashing with a beep sound alert.

VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY

Static Display:

Press the CHANNEL button to select measurements from different remote sensors, each is set to a unique channel 1, 2 or 3.

Channel Auto-Scan Display:

To enable an automatic scan of all channels, press and hold CHANNEL, until the icon is displayed. The measurements from each remote channel will be alternately displayed with a 5 seconds viewing.

NOTE: the channel auto-scan feature can be active only if there are more than one remote sensors operating and are set to different channels.

PROGRAMMING TEMPERATURE IN CELSIUS OR FAHRENHEIT

Press and hold MODE button for 3 seconds to toggle the temperature unit in Celsius (ºC) or Fahrenheit (ºF).

SETTING TEMPERATURE ALARM

Press down button to select temp display.

Press ALARM button selecting the desired alarm, the upper temperature alert with icon (if disabled, displays OFF), or lower temperature alert with icon (if disabled, displays OFF).

Press and hold ALARM button until the temperature digits flashing.

Adjust the temperature digits using the UP (? ) or DOWN (? ). Press and hold either button for fast digits advance

Press the ALARM to confirm selection and return to the temperature alarm selection screen

ACTIVATING OR DEACTIVATING TEMPERATURE ALARMS

• Once the above alerts are displayed, press the UP (? ) or DOWN (? ) to enable or disable the corresponding alert.

VIEWING MAX/MIN AND MINIMUM READINNGS

Press the MEM/ HISTORY button recalling:

Current temperature and humidity

Minimum temperature and humidity

Maximum temperature and humidity at the remote location.

11

Image 11
Contents Page Introduction Before YOU Begin InstallationMounting FeaturesBattery Installation Weather PlacementOperation TimeFront Rear UP button Alarm buttonMode button Channel buttonGetting Started Weather Forecast Table StandViewing Pressure and Altitude Information Setting Initial Pressure ParametersPressure Operation Select Pressure Units of MeasureChanging Pressure and Altitude Units Viewing PRESSURE, Temperature and Humidity ChartsMoon Phase Icons TEMPERATURE/ Humidity WindowActivating or Deactivating Temperature Alarms Viewing Remote Channel Temperature and HumidityProgramming Temperature in Celsius or Fahrenheit Setting Temperature AlarmWET Resetting Temperature MemoriesComfort Level Indication COMTime Zone Manual SettingsIcon Atomic Time Reception StrengthACTIVATING/ Deactivating Alarms Clock AlarmsSetting the Weekday W and Single DAY S Alarms Setting the ICE Warning Alarm PRE-ALPrecautions TroubleshootingMain Unit Indoor Temperature SpecificationsDeclaration of Conformity Battery Safety InstructionsFCC Statement Standard Warranty Information Meade Instruments Corp