Meade TE636W user manual Alarm button, Channel button, Mode button, UP button, MEM/ History button

Page 7

A. WEATHER FORECAST/ PRESSURE window

B. TEMPERATURE/ HUMIDITY window

C. CLOCK window

D. DOWN button

Select the next available mode

Press and hold for 2 seconds to search for wireless signal from remote sensor.

Decrease parameters.

E. ALARM button

When time mode has been selected, press once to display the alarm time of weekday alarm (W), single alarm (S) and pre-alarm (Pre-AL).

Hold for 2 seconds, set weekday, single or pre-alarm’s alarm time.

When temperature mode has been selected, press once to display the highest or lowest temperature alarm’s value.

Hold for 2 seconds, set the highest or lowest temperature alarm’s value.

When alarm is on, press once to stop the alarm temporarily.

F. CHANNEL button

Press to display the outdoor temperature readings of Channels 1, 2 and 3.

Hold for 2 seconds, enter into the circulation mode and outdoor temperature readings of Channels 1, 2 and 3 will be displayed automatically in every 5 seconds.

G. MODE button

When pressure mode has been selected, press once to display the local pressure, altitude and sea level.

Press and hold for 2 seconds to set altitude and sea level.

When time mode has been selected, press once to toggle between time with seconds display or time with weekday display.

Press and hold for 2 seconds, set language of the day of the week, year digit, month digit, date digit, hour format (12/ 24 hours), hour digit and minute digit. (Note: calendar format is default in month-date display).

When temperature mode has been selected, press and hold for 2 seconds to toggle the temperature unit between Celsius or Fahrenheit.

H. UP button

Press to select the next available mode

Increase the parameters

In time with seconds display mode, press and hold for 2 seconds to activate/ deactivate radio controlled time signal search manually.

In time with weekday display mode, press and hold for 2 seconds to switch time zone from Pacific, Mountain, Central to Eastern.

I. MEM/ HISTORY button

When temperature mode has been selected, press to recall the minimum or maximum temperature and humidity readings of main and remote units.

Press and hold for 2 seconds, collected memories will be cleared.

When pressure mode has been selected, press once to check the historical pressure data for the past 24 hours.

J. WALL- MOUNT hole

• A recessed opening to mount the unit on a wall

7

Image 7
Contents Page Introduction Before YOU Begin InstallationBattery Installation FeaturesMounting Weather PlacementOperation TimeFront Rear UP button Alarm buttonMode button Channel buttonGetting Started Weather Forecast Table StandViewing Pressure and Altitude Information Setting Initial Pressure ParametersPressure Operation Select Pressure Units of MeasureChanging Pressure and Altitude Units Viewing PRESSURE, Temperature and Humidity ChartsMoon Phase Icons TEMPERATURE/ Humidity WindowActivating or Deactivating Temperature Alarms Viewing Remote Channel Temperature and HumidityProgramming Temperature in Celsius or Fahrenheit Setting Temperature AlarmWET Resetting Temperature MemoriesComfort Level Indication COMTime Zone Manual SettingsIcon Atomic Time Reception StrengthACTIVATING/ Deactivating Alarms Clock AlarmsSetting the Weekday W and Single DAY S Alarms Setting the ICE Warning Alarm PRE-ALPrecautions TroubleshootingMain Unit Indoor Temperature SpecificationsFCC Statement Battery Safety InstructionsDeclaration of Conformity Standard Warranty Information Meade Instruments Corp