Meade TE636W Icon, Atomic Time Reception Strength, Manual Settings, Time Zone, Time and Calender

Page 13

ICON

Atomic Time Reception Strength

(Flashing)

Undefined data

No Reception for the past 24 hours

Weak signal, but can be decoded

Strong signal

The atomic clock receiver is programmed that it will search for the atomic time signal daily for 0:00, 3:00, 6:00, and 12:00 am.

To enable or disable the atomic time receiver, press and hold UP (? ) button for 3 seconds. If atomic time reception is activated, a tower icon will start flashing. If reception is disabled, the tower icon will disappear.

If the time signal has not been received in 8 minutes, you may set the time manually. (Refer to the MANUAL SETTINGS section).

MANUAL SETTINGS

To select the time mode, press UP (? ) or DOWN (? ) until the IN icon flashing with a beep sound alert. It is necessary to set the desired US TIME ZONE.

TIME ZONE

Press MODE button once to select hour and minutes with the day of the week display.

Select the Time Zone by pressing and holding UP (? ) button for 3 seconds

Keep holding UP (? ) button until the desired US Time Zone (Pacific, Mountain, Central or Eastern) is highlighted on the display’s US map, located to the right of the time display and above the day of the week

Release the UP (? ) button. The Time Zone is set.

TIME AND CALENDER

Press and hold MODE button until the day of week language abbreviation “ENG” will flash

Press the UP (? ) or DOWN (? ) selecting the day of the week in English, German, French, Italian, Spanish, Dutch or Swedish.

After the language of weekday is MODE, press MODE button to confirm and move to the next parameter (year)

Continue setting the year, month, day, time format (12 or 24 hours), local hour and minutes, using the same technique

After programming is complete the display will return to the default hour and minutes with seconds display.

13

Image 13
Contents Page Introduction Before YOU Begin InstallationBattery Installation FeaturesMounting Operation PlacementTime WeatherFront Rear Mode button Alarm buttonChannel button UP buttonGetting Started Weather Forecast Table StandPressure Operation Setting Initial Pressure ParametersSelect Pressure Units of Measure Viewing Pressure and Altitude InformationMoon Phase Icons Viewing PRESSURE, Temperature and Humidity ChartsTEMPERATURE/ Humidity Window Changing Pressure and Altitude UnitsProgramming Temperature in Celsius or Fahrenheit Viewing Remote Channel Temperature and HumiditySetting Temperature Alarm Activating or Deactivating Temperature AlarmsComfort Level Indication Resetting Temperature MemoriesCOM WETIcon Manual SettingsAtomic Time Reception Strength Time ZoneSetting the Weekday W and Single DAY S Alarms Clock AlarmsSetting the ICE Warning Alarm PRE-AL ACTIVATING/ Deactivating AlarmsPrecautions TroubleshootingMain Unit Indoor Temperature SpecificationsFCC Statement Battery Safety InstructionsDeclaration of Conformity Standard Warranty Information Meade Instruments Corp