Snapper LT2044 Check Tire Pressures, Before Every Spring Each Hours 100 250 Fall Use, Size, Bar

Regular

Maintenance

MAINTENANCE SCHEDULE & PROCEDURES

The following schedule should be followed for normal care of your tractor and mower.

SAFETY ITEMS	Before	Every 5	Every	Every	Every	Spring
	Each	Hours	25	100	250	& Fall
	Use		Hours	Hours	Hours
Check Safety Interlock System						•
Check Tractor Brakes						•
Check Mower Blade Stopping Time				•		•
TRACTOR MAINTENANCE ITEMS	Before	Every 5	Every	Every	Every	Spring
	Each	Hours	25	100	250	& Fall
	Use		Hours	Hours	Hours
Check Tractor/Mower for loose hardware		•
Check / Clean Cooling Fins (If Equipped)				•
Check / Adjust PTO Clutch					•
Lubricate Tractor & Mower **			•
Lubricate Rear Axle Shafts						Yearly
Clean Battery & Cables				•
Check Tire Pressure			•
Clean Deck & Check/Replace Mower Blades**				•
ENGINE MAINTENANCE ITEMS	Before	Every 5	Every	Every	Every	Spring
	Each	Hours	25	50	100	& Fall
	Use		Hours	Hours	Hours
Check Engine Oil Level	•
Check / Change Engine Air Filter *			•
Change Engine Oil *				•	•	•
Change Engine Oil & Filter *					•
Inspect Spark Plug(s) *						•
Check / Replace Fuel Filter *

• = All Models

*Refer to engine owner’s manual. Change original engine oil after initial break-in period.

**More often in hot (over 85° F: 30° C) weather or dusty operating conditions.

Check Tire Pressures

Service Interval: Every 25 Hours

Tire Pressure should be checked periodically, and maintained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires. The pressures shown provide proper traction, improve cut quality, and extend tire life.

Size	PSI	bar
22 x 10,0-8	10	0,68
20 x 8,0-8	10	0,68
15 x 6,0-6	12-14	0,82-0,96

Figure 9. Tire Pressure

17