Snapper Legacy XL 2900, Legacy XL 2000 Troubleshooting, Problem Possible Corrective Cause Action

Page 14

Troubleshooting

Locate the problem you’ve encountered in the chart below. Check the possible causes one at a time in the order list- ed. Correct any problems that are found and operate the snowthrower to see if you have eliminated the problem.

WARNING

To avoid serious injury, perform maintenance on the tractor or snowthrower only when the engine is stopped, parking brake is set, and all moving parts have stopped. Always remove the ignition key before beginning maintenance or adjustments to prevent accidental starting of the engine.

PROBLEM

POSSIBLE

CORRECTIVE

 

CAUSE

ACTION

 

 

 

Blower does not

PTO Selector in wrong position.

Put selector in forward position.

 

 

 

Blower does not lift

Hydraulics Selector in wrong position.

Switch to forward position.

 

 

 

Auger does not

Broken shear bolt.

Replace shear bolt.

rotate.

 

 

 

Faulty auger gearbox.

See your dealer.

 

 

 

Snowthrower vibrates

Faulty bearings (gearbox,

See your dealer.

excessively.

auger or discharge fan).

 

 

Auger or discharge

See your dealer.

 

fan bent or broken.

 

 

Faulty auger gearbox.

See your dealer.

 

 

 

Uneven cut on

Scraper bar is worn

Replace or reverse

bottom of blower.

back to blower

scraper bar.

 

housing.

 

 

 

 

Uneven cut on

Skid shoes out of

Check and adjust

bottom of blower.

adjustment.

shoes accordingly.

 

 

 

Discharge chute does

Discharge chute not

Lubricate discharge chute.

not rotate.

lubricated.

 

 

Something is caught

Inspect and remove

 

in discharge fan.

foreign material with

 

 

engine off and all

 

 

motion stopped.

 

Electric Motor defective.

See your dealer.

12

Image 14
Contents OPERATOR’S Manual Single-Stage SnowthrowerPage Table of Contents Safety Rules & Information Safety Rules ChildrenSafety Decals Safety DecalsRecommended Accessories Safety InformationRequired Accessories Tractor ControlsPage Checks Before Starting OperationControls Operating On SlopesOperation Maintenance MaintenanceInspect Scraper Bar Drive Shaft LubricationCheck Gear Box Oil Reversing Scraper BarShear Bolts AdjustmentsSkid Shoe Adjustment Electric Chute Rotator GearTroubleshooting Problem Possible Corrective Cause ActionInstall Front Hitch Initial InstallationInitial Installation Install Long Drive Shaft Attach Deflector Control Cable Support Arm Install Skid ShoesAssemble Discharge Chute Secure Cables Connect Electric Chute Rotator Wire HarnessAttach Short Drive Shaft to Drive Box Snowthrower Installation Snowthrower InstallationCable and Wire Routing Snowthrower Hitch & Removal Snowthrower & Hitch RemovalMount Remote Deflector Control Mounting Remote Deflector ControlRemote Deflector Control Template Hardware Identification & Torque Specifications