Initial Installation
Attach Short Drive Shaft to Drive Box
1.Grease the drive shaft coupler and chain box input shaft.
2.Install the key (A, Figure 20) into the input shaft key- way.
3.Attach the drive shaft to the input shaft (see Figure 20).
4.Secure the drive shaft using a
NOTE: The
5.Secure the key with an hex socket set screw (C, Figure 20).
Secure Cables
DRILL REMOTE DEFLECTOR CONTROL MOUNTING BRACKET HOLES
NOTE: Perform the following procedure after the snowthrower is completely installed for the first time.
1.Using the template included in the back of this manu- al, drill two 9/32” holes in the dashboard to mount the remote deflector control bracket (C, Figure 21). See template at the back of this book for instructions.
SECURE REMOTE DEFLECTOR CONTROL CABLE
NOTE: Perform the following procedure after the snowthrower is completely installed for the first time.
1.Insert the deflector control handle (B, Figure 21) into the mounting bracket (C).
2.Route the remote deflector control cable and spout rotator motor wires through the cable guide (A, Figure 22).
3.Secure the handle (B, Figure 21) using a clevis pin
(A) and hair pin clip (D).
SECURE SPOUT ROTATOR WIRE HARNESS
NOTE: Perform the following procedure after the snowthrower is completely installed for the first time.
1.Secure the spout rotator wire harness to the remote deflector control cable as shown in Figure 22 using cable ties (C).
Connect Electric Chute Rotator
Wire Harness
1.Connect the electric discharge chute rotator motor leads to the wire harness. Route the wire harness through the control cable support arm (see Figure 22).
| C |
A | B |
| |
| D |
Figure 20. Install Drive Shaft
A. Key | C. Set Screw |
B. Nut, Centerlock, | D. Capscrew, |
| A |
| B |
C
D
Figure 21. Install Remote Deflector Control
A. Clevis PinC. Mounting Bracket B. Deflector Control Handle D. Hair Pin Clip
A |
C |
B |
B |
Side of |
Snowthrower |
Figure 22. Deflector Control Cable Support Arm
A. Cable GuideC. Cable Ties B. Holes in Snowthrower
16