Snapper Legacy XL 2000, Legacy XL 2900 manual Assemble Discharge Chute, Install Skid Shoes

A

B

C

Figure 17. Assemble Discharge Chute

A.Plastite Screw

B.Hold-Down

C.Chute Ring

Assemble Discharge Chute

1.Remove the three hold downs (B, Figure 17) and plastite screws (A).

2.Lubricate the base of the discharge chute and ring gear with automotive lithium grease.

3.Remove the plastic cover (B, FIgure 18) and loosen the three taptite screws (A) securing the electric spout rotator motor.

4.Install the discharge chute and secure to the chute ring (C, Figure 17) using the three hold downs (B) and plastite screws (A).

5.Adjust the motor so that it meshes with the discharge chute ring gear and tighten the adjustment screws (A, Figure 18).

Install Skid Shoes

1.Install the skid shoes using 3/8-16 x 3/4” carriage bolts, washers, lockwashers, and nuts as shown in Figure 19.

2.Adjust the skid shoes. See Adjustments section.

Electric Chute Rotator Gear

1.Remove the plastic cover (B, Figure 18) and loosen the three taptite screws (A) securing the electric spout rotator motor.

Initial Installation

B

A

A

Figure 18. Discharge Chute Motor Adjustment

A. Adjustment Screws B. Plastic Cover

A

E

B F

C

D

Figure 19. Skid Shoe Installation

A.Carriage Bolt, 3/8-16 x 3/4”

B.Snowthrower Housing

C.Skid Shoe

D.Washer

E.Lockwasher

F.Hex Nut

2.Adjust the motor so that it meshes with the discharge chute ring gear and tighten the adjustment screws

(A).

Attach Deflector Control Cable Support Arm

1.Assemble the deflector control cable support arm (A, Figure 22) to the left side of the snowthrower using one 5/16-18 x 1” capscrew, lockwasher, and nut using the holes (B) shown in Figure 22.

15