Philips FW386C, FW65C, FW380C manual Contents General Information Safety Information

Page 9

CONTENTS

GENERAL INFORMATION

 

SAFETY INFORMATION

 

 

 

 

 

 

 

 

 

 

 

 

General Information

9

Safety Information

9

Preparation

10 - 11

Controls

12 - 13

Remote Control

14

Operating The System

14 - 15

CD

16 - 18

Tuner

18 - 20

Tape

20 - 21

Aux

21

Recording

22 - 23

Clock

24

Timer

24 - 25

Maintenance

25

Specifications

26

Troubleshooting

27

General Information

The typeplate (which contains the serial number) is located at the rear of the system.

Recording is permissible if copyright or other rights of third parties are not infringed.

This device complies with the Federal Communications Commission (FCC) rules, part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Accessories (Supplied)

Remote control

Batteries (two x AA size) for remote control

AM loop antenna

FM antenna wire

AC power cord

One pair of Surround Speakers (FW386C and FW65C only)

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. The type plate is located at the rear of your system.

When the system is switched on, do not move it around.

Place the system on a solid base (e.g. a cabinet).

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system.

Do not expose the system to excessive moisture, rain, sand or heat sources.

Under no circumstances should you repair the system yourself, as this will invalidate the warranty!

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.

To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

9

Image 9
Contents FW65C Which you should read the enclosed literature closely to For Customer UseDear Philips Magnavox product owner Congratulations on your purchase, and welcome to the familySet complies with the FCC-Rules, Part 15 and with 21 CFR AvisEnglish Class Laser ProductSafety Instructions Read before operating equipment Safety Instructions WHO is COVERED? Audio SystemContents General Information Safety Information Rear Connections PreparationAC Power Supply FM Wire Antenna ConnectionAM Antenna Connection Speaker ConnectionsFW318C ControlsTape / Tape 1 CD / CDTo start recording Play ƒ To start playbackInserting batteries into the Remote Control Remote Control Operating the SystemDemonstration mode To cancel demonstration modeSwitching the system to standby mode Switching the system onTo switch off DBB Selecting the SourceCD Direct Play Loading the CD ChangerPlaying a CD Press OpencloseDisc Change Erasing the program in the stop modeSelecting a desired track Searching for a particular passage during playbackRepeat only on remote control Shuffle only on remote controlTuner To shuffle all the discs and tracksStoring Preset Stations Tuning to radio stationsTuning to Preset Radio Stations Automatic programmingLoading a tape TapeTape Playback Rewind/Fast ForwardAUX Continuous Playback From Tape Deck 2 to Tape DeckSelecting External Equipment Recording Position of Volume or DBBFor six to seven seconds Current source will be recorded on tape deckRecording from other sources deck CD Synchro Start RecordingLoad a blank tape into tape deck Press CD, TUNER, Tape or AUXTimer Setting TimerClock Setting ClockMaintenance MaintenanceSpecifications SpecificationsSpeakers Left/Right Speakers Front Left/RightRadio Reception CD Player OperationTape Deck Operation General