Snapper ELP21602, ELP2150KWV, ELP21602E Operation, Maintenance and Storage

Page 3

IMPORTANT SAFETY INSTRUCTIONS

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage.

6.DO NOT mow near drop offs, ditches or embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

10.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

11.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

12.DO NOT operate mower without the entire grass catcher or guards in place. DO NOT point discharge at people, passing cars, windows or doors.

13.Slow down before turning.

14.Watch out for traffic when near or crossing roadways.

15.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

3

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of reach of children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

12.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents European 21 Cast Aluminum Deck Walk Mowers Series Protection for Children Slope OperationPreparation Operation Maintenance and StorageTable of Contents Familiarization IntroductionNomenclature Primer Models Recoil Start Operating InstructionsPRE-START Check List Starting & Operation 2.2.1. Engine & BladePropelling Mower Handle Height AdjustmentEngine & Blade Choke Models Recoil StartCutting Height Adjustment Installation of Grass CatcherRecycling Operation Wheel Drive Control MaintenanceService After First 5 Hours 3.2.1. Change Engine OIL Grease Level in TransmissionCheck Engine to Transmission Drive Belt Service AnnuallyStorage Procedure Check Mower BladeOn Next Repair & AdjustmentsMower Blade Replacement 4.1.1. Standard Blade Wear Limit Blade SharpeningDo not Sharpen Beyond Original Cutting Edge Blade Engine To Transmission Belt Replacement Belt ServiceBattery Service Adjustments & RepairBattery Battery Removal Battery InstallationBattery Testing NEW Battery PreparationState of Charge Digital Voltmeter Engine Will Not Problem Probable Cause Corrective ActionUsing Recoil Starter Start UsingUSE HRS Season Service Performed EachClean Sponge Element Engine Manual 100Decal Identification Forward Motion Chute Deflector Decal P/N AIR Filter Symbol Disclaimer of Warranty Year Limited WarrantyEuropean Cast Aluminum Deck Walk Mowers Series

ELP21602E, ELP21502KWV, ELP21602, ELP21502KWV, ELP21602, ELP21602E, ELP21602, ELP2150KWV, ELP21602E specifications

Snapper is known for producing high-quality lawn care equipment, and their models ELP21602E, ELP21502KWV, ELP21602, and ELP21502KWV are no exceptions. These electric lawn mowers combine innovative technology with user-friendly features designed to make lawn maintenance efficient and enjoyable.

The Snapper ELP21602E is equipped with a powerful electric motor that delivers reliable performance without the hassle of gas. Its brushless technology ensures a longer lifespan and quieter operation, enabling users to mow their lawns with minimal noise disruption. The model boasts a 21-inch cutting deck, providing a wide cutting path for a quicker mowing experience. The cutting height is adjustable, allowing users to customize their lawn’s appearance based on personal preference or seasonal requirements.

Similar to the ELP21602E, the ELP21502KWV is designed with convenience in mind. It features an ergonomic handle that offers multiple height adjustments for user comfort during extended use. The lightweight design makes it easy to maneuver around obstacles, ensuring that users can achieve a well-manicured lawn with ease.

The ELP21602 continues the trend of innovation with its lithium-ion battery technology. This model provides a powerful alternative for those seeking an eco-friendly mowing solution. The battery offers long run times that allow users to cover larger lawns without interruptions. Furthermore, the intelligent battery management system optimizes performance and prolongs battery life, ensuring reliability for several mowing seasons.

All models feature Snapper’s signature mulching capabilities, allowing users to finely chop grass clippings and distribute them back onto the lawn. This feature not only promotes a healthier lawn but also reduces the need for bagging clippings, saving time and effort. Additionally, the user can easily switch between mulching and bagging with a simple adjustment.

Safety is a paramount consideration in all Snapper products. These mowers come equipped with safety features like a blade brake that stops the blade immediately when the user releases the handle, preventing accidental injuries.

In conclusion, the Snapper ELP21602E, ELP21502KWV, ELP21602, and ELP21502KWV represent a blend of power, efficiency, and eco-friendly technology. Whether you prefer electric or battery-operated models, Snapper offers solutions tailored to meet diverse lawn care needs while ensuring user comfort and safety. With robust features and cutting-edge technology, these mowers are smart investments for any homeowner looking to maintain a pristine lawn.
Top Page Image Contents