Snapper GP215512KWV, C216012RV, GP216512RV Repair & Adjustments, Figure

Page 16

Manual background

Section 4 - REPAIR & ADJUSTMENTS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

4.3.4.Replacing Driven Disc Rubber Ring (Continued From Previous Page)

2.Using needle nose pliers, unhook the drive spring and slide the driven disc assembly off the hex shaft. See Figure 4.11.

3.Remove the five machine screws and plate which secure the rubber ring to the driven disc hub. See Figure 4.12.

4.Install new rubber ring.

5.Reverse above procedures for reassembly and installation.

DRIVEN DISC

ASSEMBLY

FIGURE 4.11

DRIVEN DISC HUB

MACHINE

SCREWS

4.3.5. Replacing Bearing In Driven Disc

If the driven disc bearing fails, remove the driven disc assembly and replace bearing as follows:

1.Remove snap ring. See Figure 4.13.

	THRUST	SHIM
	PLATE	WASHER
		SNAP
		RING
	BEARING
	REMOVE FOUR
	MACHINE SCREWS
		DRIVEN
		DISC HUB
	DRIVEN DISC	RUBBER
	DRIVEN DISC	DISC
	PLATE	DISC
	PLATE

FIGURE 4.13

2.Slide the hub assembly out of the bearing.

3.Remove the four screws.

4.Remove bearing and replace with new bearing.

5.Reassemble components in reverse order.

RUBBER

RING

PLATE

FIGURE 4.12

16

Image 16

Contents Safety Instructions & Operator’s Manual for 21” STEEL DECKWALK MOWERS COMMERCIAL MODEL SERIES PUSHIMPORTANT SAFETY INSTRUCTIONS PROTECTION FOR CHILDRENSLOPE OPERATION PREPARATIONMAINTENANCE AND STORAGE OPERATIONTABLE OF CONTENTS Section 1 - FAMILIARIZATION FIGURE1.1 INTRODUCTION 1.2 NOMENCLATURE2.1PRE-STARTCHECK LIST Section 2 - OPERATING INSTRUCTIONS2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE 2.4 HANDLE HEIGHT ADJUSTMENT 2.5CUTTING HEIGHT ADJUSTMENT2.3 STOPPING 2.6RECYCLING OPERATION - OPTIONAL ACCESSORY Section 3 - MAINTENANCE 3.1INTRODUCTIONROBIN ENGINES KAWASAKI ENGINESSection 3 – MAINTENANCE 3.3 SERVICE - ANNUALLY Section 4 - REPAIR & ADJUSTMENTS 4.3DRIVEN DISC SERVICE 4.2WHEEL DRIVE CONTROL ADJUSTMENTContinued on next page FIGURE 4.3.1. Cleaning Drive Disc & Driven Disc 4.3.4. Replacing Driven Disc Rubber Ring Section 4 - REPAIR & ADJUSTMENTS 4.3.6. Replacement Of Bearing On Pulley End Of Section 4 - REPAIR & ADJUSTMENTS TROUBLESHOOTING PROBLEMPROBABLE CAUSE CORRECTIVE ACTIONSERVICE SCHEDULE MAINTENANCE PARTS3 YEAR LIMITED WARRANTY PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE PRIMARY MAINTENANCE SERVICE NOTES SERVICE NOTES Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone: