Burner Flame Appearance and
Adjustment
���� ������ ������� |
��� ������ ���� ���� ��� �������� |
���� ������� ���� ������� |
��� ���� ���� ����� ��� �������� |
���� ���� ������� |
������� ������ ���� ��� ������� |
�� ������ ����� |
Figure 28
1.Remove the cooking grates from the gas grill.
2.Remove the flame deflectors located below the cooking grates.
3.Remove the burner tube. Undo one screw and the mounting plate on the rear of the gas grill and lift burner tube out.
4.Loosen the single setscrew that holds the venturi air shutter adjustment on the burner tube.
5.If the flame was too yellow and lazy in appearance then open the air shutter until a soft blue flame is achieved. This flame should also stay on the burner tube as shown in Figure 28.
6.Undo the setscrew and rotate the venturi cover until a soft blue flame is achieved
7.If the flame is lifting off the burner tube and the flame sounds like a blowtorch this could be that there is too much air being supplied, undo the setscrew and close the air shutter until a soft blue flame is achieved.
���� ��� �������� ��� ������ ��� ������� |
����� ����� � ���� ���� ����� �� ��������� |
Figure 29 |
16 |
