Eltax HT-153 instruction manual Connecting Speakers, Connecting Speaker Cables

CONNECTING

SPEAKERS

This well-designed DVD receiver provides optimum sound quality when the speakers used are within the range of their rated impedance.

Important

The minimum impedance of the five speaker terminals is 4 ohm; for the subwoofer, it is 8 ohm.

If you want to use only one speaker or listen

to monophonic music, do not parallel connect

individual speakers to the left and right channel terminals. See the figure on the left below.

Connecting Speaker Cables

1.Peel off approximately 1/ 2" of cable insulation

2.Tighten the wire end (#2 below)

3.Open cable terminal by pressing back on tab

4.Insert wire end into terminal

5.Release tab; make sure wire is in terminal securely

Note: To prevent damage to the circuit, care should be taken to prevent short circuiting from occurring at the positive and negative poles of the speaker cord.

12

34 5

13

Subwoofer speaker

Surround speaker

Center speaker

Surround speaker

SR SL FR FL CEN SW

AM ANTENNA FM

							DVD-RECEIVER
						MODEL:		HT-153
4	4	4	4	4	8
						POWER SOURCE:	90-240V 50~60Hz
						POWER CONSUMPTION:		130W
						ITEM NO.:		11036.01
		SPEAKER OUTPUT				SERIAL NO.:	XXXXXXXXXXXXXX

AUDIO VIDEO S-video

AUDIO INPUT		AUDIO OUTPUT	VIDEO INPUT		VIDEO OUTPUT
			VIDEO 1	VIDEO 2	VIDEO
L	L	L
R	R	R
AUX 1	AUX 2	PRE OUT	SW	COAXIAL	S-VIDEO

SCART

90-240V 50~60Hz

SCART IN/OUT

Main speaker Main speaker