Snapper 400 / 2400 manual Raising the Seat Deck, Fuel Filter

Page 18

 

 

 

 

Regular Maintenance

B

C

D

 

Figure 10. Engine Compartment

 

 

A. Fuel Tank

 

 

 

 

 

 

 

 

B. Ignition Switch

 

 

 

 

C. Battery

 

 

 

 

D. Throttle / Choke Cable

A

 

 

 

E. PTO Switch (Electric Clutch)

 

 

 

F. Air Filter

 

 

 

E

 

 

 

G. Oil Fill / Dipstick

 

 

 

 

 

 

 

F

H. Fuel Filter

 

 

 

I. Oil Drain

 

 

 

 

I

G

H

RAISING THE SEAT DECK

To gain access to the engine compartment, simply tilt the seat deck forward.

ADDING FUEL

To add fuel:

1.Remove the fuel cap (A, Figure 10).

2.Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual for specific fuel recommendations.

3.Install and hand tighten the fuel cap.

FUEL FILTER

The fuel filter is located in fuel line between fuel tank and carburetor. If filter is dirty or clogged, replace as follows. Place a container below filter to catch spilled gasoline.

1.Using a pliers, open and slide hose clamps from fuel filter.

2.Remove hoses from filter.

3.Install new filter in proper flow direction in fuel line. Secure with hose clamps. See warning at beginning of procedure.

Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.

OIL & FILTER CHANGE

Refer to engine owners manual.

CHECK / CHANGE AIR FILTER

Refer to engine owners manual.

REPLACE SPARK PLUG

Refer to engine owners manual.

17

Image 18
Contents 13HP Hydro Riders Mower Decks 16HP Hydro Riders Mower DecksTable of Contents North American Identification NumbersCE Identification TAG Markings ModelsSafety Rules & Information Safety Rules and Information Slope OperationService & Maintenance Safe Handling of GasolineNorth American Models CE Models Safety DecalsSafety Decals ALL ModelsCE Safety Icons Safety IconsThrottle Control Control FunctionsThrottle/Choke Control ChokeFeatures & Controls Adding Fuel General Operating SafetyOperational Safety Checks Checks Before StartingOperating the Rider Starting the EngineSelecting Ground & Engine Speed Stopping the RiderOperating the Mower Pushing the Rider by HandMower Removal and Installation Storage Check Tire Pressures Tire PressureRaising the Seat Deck Fuel FilterRegular Maintenance LubricationService Interval Every 100 Hours Battery MaintenanceCleaning the Battery and Cables Service Interval YearlyServicing the Mower Blades Removing The BladeTroubleshooting Adjustments & Service Troubleshooting the RiderTroubleshooting, Adjustment & Service Troubleshooting the MowerTroubleshooting the Rider Steering Wheel Adjustment Seat AdjustmentSteering Gear Adjustment CapscrewsBrake Adjustment AdjustmentsBrake Adjustment Blade Brake CheckMower Adjustments Side-To-Side LevelingFront-To-Back Leveling Battery Charging Transport Height AdjustmentSpacers Nut Rear Mower Rollers Rear Trailing Arms Mower Belt Belt ReplacementRider Drive Belt To avoid damaging belts, do not PRYTransmission DimensionsEngine ChassisOptional Accessories Replacement PartsMaintenance Items Technical ManualsLawn Care Lawn Care & Mowing Information