Figure 24.
A. | Frame | Rod | ~C. Clip |
8. | Frame |
| D. Support Rod |
Maintenance
AWARNING
The cart cover is subject to wear and deterioration. Check the cover frequently. Use a” approved replacement cover.
The cover can be rinsed with a hose when dirty. A dirty cover will inhibit the fast flow of grass clippings into the cover. Do not leave grass or leaves in the cart for a long period of time.
Operation’
AWARNING
For safety reasons grass and debris are to he removed only after engine is shut off, key removed, and all moving parts ,stopped.
IiBefore ralsmg cover, shut off engme, remove key,
BEFORE OPERATION
Clear the lawn of all sticks, stones, wire and,other debris which may be caught or thrown by the mower blades.
Clean the tube with mild detergent (other products may damage tube). The flow of grass can be seen through the tube while moving.
Check grass condition. If wet, wait until later in the day. If grass is wet plugging may occur.
For efficient bagging, air circulation under the mower deck, through the chute and into the bag is very important. For this reason, you should remove grass and debris from underside of mower deck, discharge chute and cover.
The tube and elbow can be removed as an assembly for cleaning.
INSTALLATION OF TRACTORS GRASS CHUTE TO CART COLLECTOR
IAttach the hose to the blower housing withclamp(A, figure 25) and tighten with a screwdriver or wrench.
2.Insert the elbow (H, figure 22) onto the tube.
Figure 25.
A. ClampC. Wing Nut 6. Hose
OPERATION - WITH CART COLLECTOR
AWARNING
Shut the tractor’s engine off before attaching, adjusting, or disconnecting the cart collector. Be sure the complete cart collector is in place before operating the tractor’s mower.
A WARNING
Do not tow the cart collector on slopes greater than 15 degrees. Mow up and down the face of slopes;
never across the face of any slope.
11