IEhHeesBo’t | Snapper 1691525 specs

INSTALLATION AND OPERATION - CART COLLECTOR

ASSEMBLY

1 . Remove all parts from inside the cart’s box. Open the bag of parts and sort the fasteners into groups for easier assembly of the cart (figure 16).

2.Turn cart box’on one side.

a.Bolt U-bracket to bottom of box with two 5/ 16 x 3/4 long round head bolts. Secure with two 5/ 16 lockwashers and nuts.

b. Bolt latch handle to front side of box. Place one 5/16 x I long hex bolt with 5/16 flat washer through the inside of the box. Next place a 5/ 16 flat washer, latch handle, 5/ 16 flat washer, spring washer (side with grooves on outside), and locknut. Tighten the locknut until the latch handle rnOWS slowly.

3.Bolt swivel wheel to the H-frame.

a.Place the head of the swivel (end with four slotted holes) inSide the H-frame (side with the ends bent upward).

b. Align the holes and place four 3/8 x 1 long hex bolts with 3/8 flat washers throughthe head ofthe swivel and frame.

c. Secure with four lockwashers and nuts.

4.Turn cart’s box upside down and install H-frame to U-bracket.

a. Align the two ends of the H-frame (end with the swivel wheel attached) to the U-bracket and

secure with two 1/2x I-1/4longhex boltsand l/2

locknuts.

b. DO NOT over tighten the locknuts. The box pivots at this point for dumping.

5.Turn latch handle to lock the H-frame to the cart’s box and turn cart’upright.

LATCH HANDLE

; : 2::: ;,i;E:hHee:sBo’t

2 - 5116 Spring Washers .

2 5/16 N u t s

2 Each 5/16x 3/4 Round Head Bolt,

5,,6 Lockwasher, 5/16 Nut

H-FRAME

2 Each - l/2 x l-1 /4 Hex Bolt, l/2 Locknul

SWIVEL WHEEL

4 Each - 3/B x 1 Hex Bolt, 3/B Flat Washer, 3 / B Lockwasher, 3 / B N u t