Toshiba P200 manual Installing/Removing batteries

Optional Devices

Installing/Removing batteries

Be sure to install the dry batteries provided with this product using the Remote Controller.

The procedures for installing and removing the bateries vary depending on the type of the Remote Controller. Check the type and then install or remove the bateries as instructed.

Store the battery for the remote control beyond the reach of children.

If a child swallows a battery, this might result in chocking. If it happens, contact a doctor immediately.

Observe the following precautions when using the battery of the Remote Controller.

■Do not use batteries other than those specified.

■Ensure that you insert the batteries with their polarities correctly aligned(+ or -)

■Do not recharge, heat, disassemble or shot the battery, or put it into a fire or flame.

■Do not use a battery whose ‘recommended expiration date’ has been reached, or is completely discharged.

■Do not use different type of battery or old and new batteries at the same time.

■Do not carry the battery together with metal necklaces, hairpins or other metal accessories.

■When storing or disposing of used batteries, make sure to put some insulation tape on their terminal (+ and -) to avoid short-circuits.

If these precausions are not followed, heating, fluid leakage or explosion may occur. This may cause bums or personal injury. If battery fluid gets on your skin or clothes, wash immediately with clean water. If battery fluid gets in your eyes, rinse your eyes with clean water immediately and see a doctor. Do not touch the battery fluid on instruments or devices with bare hands. Wipe off with a cloth or paper towel.

Type of battery that can be used for the Remote Controller

When batteries shipped with the Remote Controller are discharged, replace them with commercially available AA manganese batteries or AA alkaline batteries. Other types or battery should not be used.

9-20 Satellite P200/Satellite Pro P200