Installation

Caution concerning the installation location

1 Remove the mounting sleeve from the main unit (see “Removal” on page 66).

Slide the unit into the mounting sleeve and secure it. The supplied face plate may be mounted.

Mounting Sleeve (Included)

Dashboard

This unit

Pressure Plates*

Face Plate (Included)

*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.

Removal

1.Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.

This unit

Bracket keys (Included)

2. Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Take the face plate off, and secure the ground lead of the unit to a clean metal spot using a screw (*) already attached to the car’s chassis.

Attach the Original Mounting Bracket to each side of the iXA-W407, using the screws supplied with iXA-W407.

Screws (M5 × 8) (Included)

2

Hex Nut (M5)

Screw

Ground Lead

*

Mounting

*2

Metal

Mounting

Strap*1

Bolt Stud

Bracket

Chassis

Face Plate (Included)

Ground Lead

This unit

Chassis

Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle’s chassis.

For the screw marked “*2”, use an appropriate screw for the chosen

mounting location.

Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the iXA-W407. Connect all other leads of the iXA-W407 according to details described in the CONNECTlONS section.

3 Slide the iXA-W407 into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard.

66-EN

Page 68
Image 68
Alpine iXA-W407 owner manual Installation, 66-EN, Removal, Pull the unit out, keeping it unlocked as you do so