MultiInfo Setup
MultiInfo Setup Operation
To display the MultiInfo mode screen:
To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.
1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.
2Keep pushing the foot brake and release the parking brake once then engage it again.
3When the parking brake is engaged for the second time, release the foot brake.
•For automatic transmission vehicles, place the transmission lever in the Park position.
Now, the locking system for the MultiInfo mode operation has been released. Engaging the parking brake can reactivate the MultiInfo mode, as long as the car’s ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3) of “To display the MultiInfo mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To display the MultiInfo mode screen.”
The following steps 1 to 6 are common operations to each “Setting item” of MultiInfo Setup. Refer to each section for details.
1 Press and hold SETUP of the unit for at least 2 seconds.
The SETUP selection screen is displayed.
2 Touch [ 
] of MultiInfo Setup.
The Multi Info Setup screen appears.
•While in Multi Information mode, you can also recall MULTI INFO SETUP screen directly by pressing SETUP.
Display example for MULTIINFO SETUP screen
ADisplays the MultiInfo item selection list.
BDisplays the selected MultiInfo item. (If no item is selected, the default items will be displayed.)
3 Touch [
] or [
] until the desired item is displayed in the A list.
Setting items:
Clock / Calendar / Calculator / AV Info / AV Cont / Sound Cont. /
IMPRINT*
*You can set this item only when an IMPRINT audio processor
22-EN
4 Touch the desired item.
(e.g. touch [Calendar])
5 Touch a present item in B that you want to replace.
(e.g. [AV Cont])
The
(e.g. AV Controller will be replaced as Calendar)
6 Touch [
] to return to the previous screen.
Touch and hold [ ] for at least 2 seconds to return to the main source screen that was displayed before the setup operation was started.
•For detailed content and operations of the selected MultiInfo item, refer to “Multi Information Function” on page 12.
•The selected item in the A list is shown as ineffective (inoperative) status.
