Setting the External Device Interrupt Mode
If an Alpine
Setting item: IN Int. Mute
Setting contents: OFF / ON
OFF: The volume level can be adjusted in Interrupt mode.
ON: Sound will not be output. The icon that is set in “Setting the Interrupt Icon Display” is displayed.
•The setting item displayed only when Bluetooth IN is OFF.
•The auxiliary device being connected must have an Interrupt wire with a negative trigger for this function to operate automatically. Otherwise, a separate switch needs to be added to switch it manually.
Setting the Interrupt Icon Display
The unit can display the icon of an external device, such as a telephone, whenever a phone call comes in to tell you there is a phone call.
Setting item: IN Int. Icon
Setting contents: INT / TEL
INT: The INT icon appears on the display.
TEL: When the external device (telephone) sends the interrupt
signal, the telephone icon appears on the display.
Switching the function of the remote sensor
For remote control operation, the remote sensor of the external device (monitor, etc.) can be switched, as you prefer.
Setting item: Remote Sensor
Setting contents: FRONT / REAR
FRONT: The remote sensor of this unit is effective.
REAR: The remote sensor of the external monitor connected to AUX OUT of this unit becomes effective. The remote control operates the source connected to the AUX OUT terminals.
•If a touch screen monitor (connected to the Rear Monitor output using the Monitor control lead) is touched, the command is executed regardless of the remote control sensor setting. Note, however, that the remote control sensor that has been set takes priority if it has been 5 seconds since last touching the panel.
•When an optional DVD changer is connected, and the remote control
sensor is set to REAR, some soft button operations ( [ 
] STOP, etc.) cannot be performed. In this case, set the remote control sensor to
FRONT.
Setting the Rear Camera Input
With a rear camera connected, rear view video is output to the monitor.
Setting item: Camera IN
Setting contents: OFF / DIRECT / RCA
OFF: The Camera mode is not displayed in the mode switching screen.
DIRECT: Use when the optional rearview camera
RCA: Use when connecting an optional rearview camera with RCA output connector.
•By shifting to reverse (R), the rear pictures are output. This function is effective when the reverse wire is properly connected.
Setting the Navigation Mode
When you connect an optional navigation device, set it to ON.
Setting item: NAV. IN
Setting contents: OFF / ON
OFF: Navigation mode is not displayed. The settings related to the navigation can not be changed from this unit.
ON: Navigation mode is displayed.
Setting the Navigation Interruption
With an Alpine navigation system connected to the
Setting item: NAV. Mix
Setting contents: OFF / ON
OFF: The navigation interruption mode is turned off.
ON: The navigation interruption mode is on.
See “Adjusting NAV. Mix Level” under “Adjusting the Audio” on page 11 to set the navigation interruption volume level.
•The volume level for voice prompts during navigation guidance is set by adjusting the volume while the prompts are announced. When the announcement finishes, the normal audio volume and the previous audio screen are restored. The voice prompt volume is always at or below the current listening volume. If a navigation announcement cuts in while adjusting the audio level, it always resets to the current level regardless of the audio level setting.
•This setting is effective when NAV. IN of SYSTEM list screen is ON.
Setting the AUX Mode
This unit has two sets of AUX IN terminal. You can set the AUX1 IN and AUX2 IN to ON or OFF.
Setting item: AUX1 IN (AUX2 IN)
Setting contents: OFF / ON
OFF: AUX source is not displayed.
ON: AUX source is displayed.
•For AUX2 IN, OFF is not displayed when the optional DVD player or DVD changer is connected. During System setup, although the AUX name can be changed, it is not displayed on the Audio/Visual source selection screen.
•When OFF is selected, the settings related to AUX cannot be changed from this unit.
