Toshiba P200 manual Disk drive, Real Time Clock

Troubleshooting

Problem	Procedure
Cannot write correctly	If you have trouble writing, make sure you are
	observing the following precautions:
	■ Use only media recommended by TOSHIBA.
	■ Do not use the mouse or keyboard during
	writing.
	■ Use only the software supplied with the
	computer for recording.
	■ Do not run or start other software during
	writing.
	■ Do not jar the computer during writing.
	■ Do not connect/ disconnect external devices
	or install/remove internal cards during writing.
	If problems persist, contact your dealer.

Disk drive

For information on disk care refer to Chapter 4, Operating Basics.

Problem	Procedure
Some programs run	The software or hardware configuration may be
correctly, but others do	causing a problem. Make sure the hardware
not	configuration match's your software's needs.
You cannot access the	Try another disk. If you can access this disk, the
disk drive	original disk (not the disk drive) is problem.
	If problems persist, contact your dealer.

Real Time Clock

ProblemProcedure

The followingmessage is displayed on the LCD:

RTC battery is low or CMOS checksum is inconsistent. Press [F2] key to set Date/ Time.

The RTC battery charge has become exhausted, you should set the date and time in within the BIOS setup screen through the following steps:

1.Press [F1] key. BIOS setup will boot up.

2.Press [F2] to set the date in [System Date].

3.Press [F2] to set the time in [System Time].

10-16 Satellite P200/Satellite Pro P200