HOW TO ASSEMBLE
CAUTION: Completely assemble vacuum cleaner before using.
Assembly Packet is with ownerʼs guide.
A | B | C | D |
Upper | Lower | Bag | |
Bolt | Cord Hook | Cord Hook | Screws |
Step 1
Attach the Handle
Push the handle sections together. Note: Check to be sure slots in handle are correct, see Detail A.
Align the holes in the handle. Insert a
Push handle into the handle socket so handle grip curves away from the cleaner. Align the holes, insert the other
Step 2
Attach Upper Cord Hook
Pull the flexible cord support up toward the top of the handle.
Insert the lower half of the cord support into the upper cord hook.
Check to be sure slots in handle are correct, see Detail A. Place inner tab of cord hook into handle slot as shown (1) and press hook handle (2) SNAPPING opposite inner tab into place (3).
Flexible
SCord
Support
Upper Cord Hook
1. Place inner | 2. Press hook | 3. SNAP opposite |
tab into slot | around handle | inner tab into |
|
| place |
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower cord hook. Snap the hook into the lower handle.
Pull up on the cord to tighten but leave enough slack near the base so there is no strain on the cord when the handle is lower.
Lower Cord Hook
Step 4
Store Electrical Cord
Wrap the cord around the two cord hooks. Fasten the plug to the electrical cord to prevent unwinding.
Step 5
Attach Outer Bag
IMPORTANT: To provide a good gasket seal, the bag
Acoupling must seat firmly against the motor base and not overlap the furniture guard.
Hold outer bag with zipper away from the handle. Start the bag screws (D) by hand, then tighten with a screwdriver.
Loop the bag spring onto the bag support hook on the back of the upper cord hook.
D
3
