Micron Filter® Bag Care
(Micron Filter Bag is standard on some models)
Because the Micron Filter Bag is an effective fi lter medium, occasionally trapped dust particles will need to be cleaned from the inside of it. The dust accumulation can be vacuumed out with another vacuum or the bag may be removed to shake out. If you desire, the bag may be hand laundered. The zipper on the bag should be down and the bag should remain right side out. Use warm water (150°F 65°C) and a mild detergent.
DO NOT USE AN AUTOMATIC WASHER OR DRYER as either will cause abrasion to the delicate polyester fabric. DO NOT DRY CLEAN as dry cleaning fl uids will damage plastic parts of your bag assembly.
Cleaner Care
CAUTION : Turn off the switch and unplug the electrical cord before cleaning unit.
To keep the vacuum cleaner looking new, it can be wiped with a damp cloth and a mild soap solution, then thoroughly dried. Never use any type of chemical as chemicals can damage the cleaner. When not in use, the cleaner should be stored in a clean, dry place.
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the brush to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
How To Replace A Worn Belt
PN 52100A, Style RD
CAUTION : Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
IMPORTANT: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
1. Release cam locks.
2 Motor
Pulley
2.Pull up on belt to rotate it off the motor pulley. Lift up on brush rolL and remove worn belt.
Check for brush wear (see Brush Roll instructions).
3.Place new belt around brush roll.
4.Align brush roll pulley with belt guide.
5
6
Metal Brush Roll only.
Place rubber end cap covers (available on select models) over both end caps (fl at side against end cap). Align holes and secure.
5.Slant brush roll forward so end caps are in line with slots in cleaner base.
6.Push brush roll into base.
7
7.Place lower side of belt into belt guide and pull to stretch the belt around the left side of motor pulley. Rotate pulley to secure belt into groove.
8.Place slots of bottom
plate over tabs of cleaner base.
9.Seat and secure cam locks.
8 8
Ask for GENUINE EUREKA replacement belts, No. 52100A
GENUINE
Look for the 
symbol.
5
