Snapper 3011523BV Operation Stopping Engine, Wheel Drive, Blade, Cutting Height Adjustment

Page 13

Operation (Continued)

Stopping - Engine, Wheel Drive,

Cutting Height Adjustment

Blade (Continued)

1. Adjust the cutting height by raising or lowering the deck

lift lever (A, Figure 18) into the desired height of cut

Park Brake

notch (B).

1.To set the park brake, press the clutch/brake pedal (A, Figure 16) all the way down, slide the park brake latch

(B)all the way in to the engaged position, and release the clutch/brake pedal. A detent in the park brake latch will keep the park brake engaged.

!

WARNING

!

DO NOT park the machine on slopes.

A

B

B

A

 

Figure 16: Setting the park brake

Figure 18: Cutting height adjustment

 

2.Release the park brake by pressing down firmly on the clutch/brake pedal (A, Figure 17). The park brake latch

(B)is spring-loaded, and will slide back to the disen- gaged position unassisted.

A

B

Figure 17: Releasing the park brake

Operation

11

Image 13
Contents Series Engine Date of Purchase Retailer Retailers Phone Number EquipmentSnapper is a trademark Simplicity Manufacturing, IncTable of Contents Protection against Tipovers Protection for ChildrenPreparation Do not allow pre-teenage children to operate machineOperation Safe Handling of GasolineTowing MaintenanceFeatures and Controls Features and ControlsFuel Tank Operation Pre-Start Check List OPERATOR’S Seat AdjustmentFuel filler cap A, is tight, and the vent B is Engine Electric Start Operation Starting and OperationEngine runs smooth On Next OperationEngine Manual Start Setting the park brakeMower Blade OperationWheel Drive Stop the engine by turning the key A, to the OFF position Stopping Engine Wheel Drive, BladeOperation Stopping Engine, Wheel Drive Cutting Height AdjustmentBlade Park BrakeReverse Lockout Mechanism Override Operation Reverse Lockout MechanismAte blades in reverse. Stop BLADES, Look and see While backingService After the First 5 Hours MaintenanceIntroduction Blade Drive Belt Replacement Service Brake / Park BrakeCheck the Blade Drive Belt Blade BrakeCheck Engine Safety Interlock System ChecksReverse Lockout Mechanism Lubrication Grease FittingsService Every 25 Operating Hours Rear Axle Bearing Lubrication Engine ServiceDifferential / Chain Case Lubrication Every Two Years Service AnnuallyStorage Out of Season Removing the Fuel TankMower Deck and Component Adjustments Engine Adjustments and RepairBlade Brake Adjustment Reinstall the belt cover and tighten the bolts securelyMower Deck Adjustment Front-to-Rear Levelness Mower Deck Adjustment Side-To-Side LevelnessService BRAKE/PARK Brake Adjustment Mower Drive Belt Adjustment For 28 & 30 Decks OnlyMove the blade lever up and over to the on position To the rear main caseMeasurement should be 3/4 Rear Engine Rider Drive ComponentsBlade Wear Limits Mower Blade ReplacementSigns of excessive wear or damage Blade Sharpening Belt Removal Belt ReplacementRemove the idler A, Figures 46 Battery Removal BatteryBattery Installation Slide the battery partially into the battery housingBattery Storage Battery ServiceNew Battery Preparation Battery TestingBattery Condition Chart Snapper Rear Engine Rider AccessoriesDescription of Kit Models Used on Season Maintenance Service ScheduleMaintenance Maintenance/Replacement Parts Problem Probable Cause Corrective Action TroubleshootingStop Move lever to the on position Year Limited Warranty Slope Guide Page Page Page Page Common Service Parts Product Specifications2811523BV 2812523BVE Snapper Products Macon Street McDonough, GA