Snapper ELP21702BV important safety instructions

Page 19
(8)HEIGHT CONTROL INSTRUCTION: Shows direction of movement of HEIGHT ADJUST HANDLE to select a change in height if cut from highest cutting height (clockwise) to the lowest height (counter- clockwise). Note that there is a total of eleven heights of cut.

DECAL IDENTIFICATION

 

 

FORWARD MOTION

 

 

FAST SPEED

GROUND

 

(RABBIT)

 

 

SPEED

 

3rd TOP SPEED

DECAL

 

 

P/N 4-7158

 

 

 

 

2nd MEDIUM SPEED

 

 

1st SLOW SPEED

 

 

(TURTLE)

 

 

 

(7)GROUND SPEED: Shows direction of movement and the ability to select one of three ground speeds by moving the lever. The number 3 (Rabbit) indicates the top speed, number 2 indicates the medium speed and the number 1 (Turtle) indicates the slowest speed.

HEIGHT

CONTROL

DECAL

Manual background P/N 2-8454

(8)HEIGHT CONTROL INSTRUCTION: Shows direction of movement of HEIGHT ADJUST HANDLE to select a change in height if cut from highest cutting height (clockwise) to the lowest height (counter- clockwise). Note that there is a total of eleven heights of cut.

EUROPEAN

COMMUNITY

DECAL

29776

(10)EUROPEAN PERFORMANCE: Maximum level of vibration measured at the operators hand is 23.4 m/sec2.

OPERATOR PRESENCE

CONTROL DECAL

P/N 2-9431

(11)OPERATOR PRESENCE CONTROL: Pull control against handle to start engine and blade. Release control to stop engine and blade.

 

GROUND DRIVE

EUROPEAN NOISE

DECAL

CONTROL DECAL

P/N 2-9432

74135

 

(12) GROUND DRIVE: Pull lever against handle to engage drive. Release lever to disengage drive.

(9)NOISE CONTROL: This unit is certified to be within the 100 dBA sound power limit at the specified Engine RPM.

19

Image 19
Contents SELF-PROPELLED MODEL ELP21702BV Safety Instructions & Operator’s Manual forPREPARATION IMPORTANT SAFETY INSTRUCTIONSPROTECTION FOR CHILDREN SLOPE OPERATIONOPERATION MAINTENANCE AND STORAGETABLE OF CONTENTS 1.2 NOMENCLATURE Section 1 - FAMILIARIZATIONFIGURE 1.1 INTRODUCTIONPrimer Models Recoil Start Section 2 - OPERATING INSTRUCTIONS2.1PRE-STARTCHECK LIST 2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE2.2.3.PROPELLING MOWER 2.4HANDLE HEIGHT ADJUSTMENTFIGURE 2.2.2.ENGINE & BLADE Choke Models Recoil Start2.5CUTTING HEIGHT ADJUSTMENT 3.2.3. WHEEL DRIVE CONTROL Section 3 - MAINTENANCE3.1INTRODUCTION 3.2.2. GREASE LEVEL IN TRANSMISSION3.2.4. CHECK MOWER BLADE Section 4 - REPAIR & ADJUSTMENTS CUTTING EDGE OF THUMBWHEEL ADJUSTERDO NOTSHARPEN BEYOND ORIGINAL4.3BELT SERVICE Section 4 - ADJUSTMENTS & REPAIR Battery Condition Chart Start Using TROUBLESHOOTINGPROBLEM Using Recoil StarterMAINTENANCE/REPLACEMENT PARTS MAINTENANCE PARTS MAINTENANCE SCHEDULE1 WARNING INSTRUCTIONS DECAL IDENTIFICATION8HEIGHT CONTROL INSTRUCTION: Shows direction of movement of HEIGHT ADJUST HANDLE to select a change in height if cut from highest cutting height clockwise to the lowest height counter- clockwise. Note that there is a total of eleven heights of cut CHUTE DEFLECTOR DECAL P/N AIR FILTER SYMBOL P/NDECAL P/N 2 YEAR LIMITED WARRANTY NOTES NOTES SERIES EUROPEAN 21” CAST ALUMINUM DECK WALK MOWERS