Snapper ELP21702BV EUROPEAN 21” CAST ALUMINUM DECK WALK MOWERS, Series

Page 24
EUROPEAN

Safety Instructions & Operator’s Manual for

EUROPEAN

21” CAST ALUMINUM DECK WALK MOWERS

SERIES 2

IMPORTANT

Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments. If you have any questions about your Snapper product, contact your local authorized Snapper dealer or contact Snapper Customer Service at Snapper, McDonough, GA. 30253. Phone: (1-800-935-2967).

SERIES 2 WARNING

BATTERY POSTS, TERMINALS AND RELATED ACCESSORIES CONTAIN LEAD AND LEAD COMPOUNDS, CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER HANDLING.

Manual background WARNING

ENGINE EXHAUST, SOME OF ITS CONSTITUENTS, AND CERTAIN VEHICLE COMPONENTS CONTAIN OR EMIT CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER OR OTHER REPRODUCTIVE HARM.

COPYRIGHT © 2003

SNAPPER PRODUCTS INC.

ALL RIGHTS RESERVED

MANUAL No. 7-5519 (I.R. 3/11/03)

24

Image 24
Contents Safety Instructions & Operator’s Manual for SELF-PROPELLED MODEL ELP21702BVIMPORTANT SAFETY INSTRUCTIONS PROTECTION FOR CHILDRENSLOPE OPERATION PREPARATIONMAINTENANCE AND STORAGE OPERATIONTABLE OF CONTENTS Section 1 - FAMILIARIZATION FIGURE1.1 INTRODUCTION 1.2 NOMENCLATURESection 2 - OPERATING INSTRUCTIONS 2.1PRE-STARTCHECK LIST2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE Primer Models Recoil Start2.4HANDLE HEIGHT ADJUSTMENT FIGURE 2.2.2.ENGINE & BLADEChoke Models Recoil Start 2.2.3.PROPELLING MOWER2.5CUTTING HEIGHT ADJUSTMENT Section 3 - MAINTENANCE 3.1INTRODUCTION3.2.2. GREASE LEVEL IN TRANSMISSION 3.2.3. WHEEL DRIVE CONTROL3.2.4. CHECK MOWER BLADE Section 4 - REPAIR & ADJUSTMENTS THUMBWHEEL ADJUSTER DO NOTSHARPENBEYOND ORIGINAL CUTTING EDGE OF4.3BELT SERVICE Section 4 - ADJUSTMENTS & REPAIR Battery Condition Chart TROUBLESHOOTING PROBLEMUsing Recoil Starter Start UsingMAINTENANCE SCHEDULE MAINTENANCE/REPLACEMENT PARTS MAINTENANCE PARTSDECAL IDENTIFICATION 1 WARNING INSTRUCTIONS8HEIGHT CONTROL INSTRUCTION: Shows direction of movement of HEIGHT ADJUST HANDLE to select a change in height if cut from highest cutting height clockwise to the lowest height counter- clockwise. Note that there is a total of eleven heights of cut AIR FILTER SYMBOL P/N CHUTE DEFLECTOR DECAL P/NDECAL P/N 2 YEAR LIMITED WARRANTY NOTES NOTES EUROPEAN 21” CAST ALUMINUM DECK WALK MOWERS SERIES