Snapper GT600 manual Safety Rules & Information, General Operation

Page 6

Safety Rules & Information

Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment.

This mowing deck is capable of amputating hands and feet and throwing objects.

The triangle in text signifies important cautions or warnings which must be followed.

GENERAL OPERATION

1.Read, understand, and follow all instructions in the manual and on the unit before starting.

2.Do not put hands or feet near rotating parts or under the machine. Keep clear of the discharge opening at all times.

3.Only allow responsible adults, who are familiar with the instructions, to operate the unit (local regulations can restrict operator age).

4.Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade(s).

5.Be sure the area is clear of other people before mow- ing. Stop the unit if anyone enters the area.

6.Never carry passengers.

7.Do not mow in reverse unless absolutely necessary. Always look down and behind before and while travel- ling in reverse.

8.Never direct discharge material toward anyone. Avoid discharging material against a wall or obstruc- tion. Material may ricochet back toward the operator. Stop the blade(s) when crossing gravel surfaces.

9.Do not operate the machine without the entire grass catcher, discharge guard (deflector), or other safety devices in place.

10.Slow down before turning.

11.Never leave a running unit unattended. Always disen- gage the PTO, set parking brake, stop engine, and remove keys before dismounting.

12.Disengage blades (PTO) when not mowing. Shut off engine and wait for all parts to come to a complete stop before cleaning the machine, removing the grass catcher, or unclogging the discharge guard.

13.Operate the machine only in daylight or good artificial light.

14.Do not operate the unit while under the influence of alcohol or drugs.

15Watch for traffic when operating near or crossing roadways.

16.Use extra care when loading or unloading the unit into a trailer or truck.

17.Always wear eye protection when operating this unit.

18.Data indicates that operators, age 60 years and above, are involved in a large percentage of power equipment-related injuries. These operators should evaluate their ability to operate the equipment safely enough to protect themselves and others from injury.

19.Follow the manufacturer’s recommendations for wheel weights or counterweights.

20.Keep in mind the operator is responsible for accidents occurring to other people or property.

21.All drivers should seek and obtain professional and practical instruction.

22.Always wear substantial footwear and trousers. Never operate when barefoot or wearing sandals.

23.Before using, always visually check that the blades and blade hardware are present, intact, and secure. Replace worn or damaged parts.

24.Disengage attachments before: refueling, removing an attachment, making adjustments (unless the adjustment can be made from the operator’s posi- tion).

25.When the machine is parked, stored, or left unattend- ed, lower the cutting means unless a positive mechanical lock is used.

26.Before leaving the operator’s position for any reason, engage the parking brake (if equipped), disengage the PTO, stop the engine, and remove the key.

27.To reduce fire hazard, keep the unit free of grass, leaves, & excess oil. Do not stop or park over dry leaves, grass, or combustible materials.

28.It is a violation of California Public Resource Code Section 4442 to use or operate the engine on or near any forest-covered, brush-covered, or grass-covered land unless the exhaust system is equipped with a spark arrester meeting any applicable local or state laws. Other states or federal areas may have similar laws.

TRANSPORTING AND STORAGE

1.When transporting the unit on an open trailer, make sure it is facing forward, in the direction of travel. If the unit is facing backwards, wind lift could damage the unit.

2.Always observe safe refueling and fuel handling prac- tices when refueling the unit after transportation or storage.

3.Never store the unit (with fuel) in an enclosed poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also toxic to humans and animals.

4.Always follow the engine manual instructions for storage preparations before storing the unit for both short and long term periods.

5.Always follow the engine manual instructions for proper start-up procedures when returning the unit to service.

6.Never store the unit or fuel container inside where there is an open flame or pilot light, such as in a water heater. Allow unit to cool before storing.

4

Image 6
Contents OPERATOR’S Manual 27HP Hydro Tractors & Mower DecksPage Table of Contents Safety Rules & Information Operating Safety Safety Rules and Information Slope OperationSafety Rules & Information General OperationIgnition System Service & Maintenance Safe Handling of GasolineIdentification Numbers Tractor ID TagDecal Danger Rotating Blades Safety DecalsSafety Decals Decal Danger, Rotating Fan, Diesel Models Part NoSafety Icons Operational Safety ChecksControl Functions Features & Controls Parking Brake Function Automatic Controlled TractionDashboard Display Functions Adding Fuel General Operating SafetySlope Operation Stopping The Tractor & EngineOperating the Tractor Hydraulic System Functions Using Inboard HydraulicsPushing The Tractor By Hand GeneralUsing Auxiliary Hydraulics Auxiliary Hydraulics Angle Left Angle RightAttachment Weight Limit Optional 3-Point Hitch Operation Select ModelsLocking The Hitch Hitch Arms Installation Checks Before Starting Connecting a Drive ShaftRear PTO Operation Select Models Starting & Stopping the PTOAttachment Recommendations Mower Deck Removal & Installation Removing the Mower DeckInstalling the Mower Deck Mower Electrical ConnectionVolt Power Outlet Attaching a TrailerStorage Regular Maintenance Before Every Spring Each Hours Fall UseClean Transmission Oil Cooler Regular MaintenanceClean Radiator Check Engine Coolant LevelService Interval Seasonally or as Needed Drain Fuel SeparatorService Interval Every 25 Hours Check Transmission Oil LevelChange Transmission Oil & filter Check Front Axle Oil LevelOil Filter Part No Service Interval Every 100 Hours or Fall & Spring Safety Interlock System CheckService Interval Every Fall & Spring Check Mower Deck Gear Box OilCheck Tire Pressures Battery MaintenanceCleaning the Battery and Cables Size TreadLubrication GreaseOil Fitting Yearly Grease the ElectricLift Rod Grease Arm Grease Fitting YearlyServicing The Mower Blades Removing the BladeMaintenance Records Troubleshooting Adjustment, & Service Troubleshooting the Mower Brake Adjustment Troubleshooting, Adjustment, & ServiceSeat Adjustment Seat Slide AdjustmentHeadlight Replacement Taillight & Dash Light ReplacementBattery Charging Mower Adjustments Gauge Wheel AdjustmentSide-to-Side Adjustment Lock Nut, 5/16-18 Spacer Bolt Leveling The MowerMower Belt Replacement Mower Drive Belt ReplacementTo avoid damaging belts, do not PRY Specifications 27 HP* Briggs & StrattonOptional Accessories Replacement PartsMaintenance Items Technical ManualsPage Lawn Care Lawn Care & Mowing Information Page