Snapper ELP21703BDV specifications Operation Pre-Start Check List, Engine and Blade

Page 9

Operation

Pre-Start Check List

Starting and Operation

Make the following checks and perform the service required before each start-up.

1.Check the guards, deflectors, grass bag, adapter, and covers to make sure all are in place and securely tightened.

2.Check the blade control (A, Figure 1), wheel drive control (B), and ground speed control (C) to insure they work freely.

Engine and Blade

1.Move the engine speed control (C, Figure 3) past the fast (‘Rabbit’) detent to the ‘Choke’ position.

2.Pull the blade control (A, Figure 3) against the handle.

3.Pull the rope start handle (B) to crank the engine.

4 . After the engine starts, allow a brief warm-up until the engine runs smooth, then turn off choke.

A

C

B

Figure 1: Mower controls

3.Check the cutting height. Adjust to the desired height. Refer to the Section entitled ‘Cutting Height Adjustment’.

4.Check the engine oil (A, Figure 2) and add oil as needed to bring the level up to the full mark. Refer to the Engine Owner’s Manual for oil specifications.

NOTE: To stop the engine (and blade), release the blade control.

 

A

C

 

B

Operation

 

Figure 3: Starting the mower

A

B

Figure 2: Oil and fuel fill

5.Add fuel to the tank after pushing the mower outside where fumes can safely dissipate. Fill the tank to 1-1/2 inches below the top of the filler neck (to allow for fuel expansion). Make sure the cap (B, Figure 2) is tightened after fueling. Refer to the Engine Owners Manual for fuel specifications.

6.Clean the exterior surfaces of the cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep the engine air intake screen and cooling fins clear at all times.

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents European 21 Cast Aluminum Deck Walk Mowers Series Engine Date of Purchase Retailer Retailers Phone Number EquipmentSnapper is a trademark Simplicity Manufacturing, IncTable of Contents Slope Operation Protection for ChildrenPreparation From Previous Column PreparationSafe Handling of Gasoline From Previous Maintenance and StorageOperation Operation From Previous ColumnSerial Tag Decal IdentificationEngine Speed Control Operator Safety Speed SelectorOperator Presence Control OPC ClutchFeatures and Controls Features and ControlsDischarge Door Grass Catcher Engine and Blade Operation Pre-Start Check ListOperation StoppingPropelling the Mower Recycling Operation Cutting Height AdjustmentInstalling the Grass Catcher Installing the Grass CatcherService After First 5 Hours Maintenance Maintenance IntroductionGrease Level in Transmission Change Engine OilMaintenance Service PeriodicStorage Procedure Mower Blade Replacement Standard Blade Wear LimitBlade Sharpening When proper belt tension has been set, operate AdjustmentOperating the mower Check for proper drive belt tensionEngine To Transmission Belt Replacement Belt ServiceMaintenance/Replacement Parts Maintenance Service ScheduleProbable Cause Corrective Action TroubleshootingYear Limited Warranty Slope Guide Page Page Product Specifications Common Service Parts Part NumberSnapper Products Macon Street McDonough, GA
Top Page Image Contents