Snapper RP2167517BVE important safety instructions Operation

Page 3

IMPORTANT SAFETY INSTRUCTIONS

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower

vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage.

6.DO NOT mow near drop offs, ditches or

embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

10.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

11.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

12.DO NOT operate mower without the entire grass catcher or guards in place. DO NOT point

discharge at people, passing cars, windows or doors.

13.Slow down before turning.

14.Watch out for traffic when near or crossing roadways.

15.DO NOT operate engine in enclosed areas.

Engine exhaust gases contain carbon monoxide, a deadly poison.

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow

engine to cool before storing machine in an enclosure. Store fuel container out of reach of

children in a well ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

9.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

10.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

11.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

12.Use only genuine SNAPPER replacement parts

to assure that original standards are maintained.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents 8NAPPERo McDonough, GA., 30253 U.S.A Engine Designation Series Designation Engine Horse PowerImportant Safety Instructions Operation Table of Contents Control BriggsEngine SpeedPRE-START Check List Starting & Operation Engine & BladePrimer Models Starting & Operation 2.2.1. Engine & Blade Propelling MowerStopping Cutting Height Adjustment Handle Height AdjustmentOn Next Recycling OperationRemoving and Dumping Grass Catcher Installation of Grass Catcher Slide Closure TypeComponents immediately Service After First 5 Hours 3.2.1. Change Engine OIL IntroductionImportant Drain fuel tank before tipping machine Check Mower Blade Service -ANNUALLYStorage Procedure Important Drain fuel tank before tipping mower. do1.A. Ninja Blade Wear Limit Mower Blade ReplacementStandard Blade Wear Limit Blade SharpeningWheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementReplacing Rubber Driven Disc Repair & Adjustments Replacement Of Bearing On Pulley End Hex Shaft Belt ServiceEngine Drive Belt Replacement Stretch Type Belts Transmission Poly-V Belt Replacement Pulley PositionImportant 1 The square shoulder of the drive Syringe Hydrometer Digital Voltmeter Battery Service NEW Battery PreparationBattery Storage Battery TestingTroubleshooting Service Performed Each USE HRS MAINTENANCE/REPLACEMENT PartsHRS HRS HRS Season Disclaimer of Warranty Year Limited WarrantyVs.DIRT That dirt will Cost YOU MoneyCheck OIL Level Before Each START-UP Spark plug Starting Check USTSnapper Product Registration Form Page Page Page Snapper McDonough, GA., 30253 U.S.A Steel Deck Walk Behind Mowers Series

RP2167517BVE specifications

The Snapper RP2167517BVE is a versatile and powerful riding mower, engineered for homeowners seeking efficiency and comfort in lawn care. Designed with a 21 horsepower Briggs & Stratton engine, this mower provides more than just power; it boasts exceptional reliability, ensuring a consistent performance on various terrains. One of its standout features is the professional-grade, 42-inch dual-blade cutting deck, which allows for precise cutting and an impressive turnaround radius that enhances maneuverability around your yard.

Equipped with a unique hydrostatic transmission, the RP2167517BVE offers seamless speed control and smooth handling, allowing users to easily navigate tricky landscapes. The foot-operated automatic transmission provides the rider with the ability to accelerate or decelerate without the complexity of manual shifting. This means that mowing becomes less of a chore and more of an enjoyable task, even in larger properties.

Comfort is a major highlight of the Snapper RP2167517BVE. It comes with an adjustable high-back seat designed to reduce fatigue during extended mowing sessions. The position is customizable to suit different user preferences, allowing for an ergonomic driving experience. Furthermore, the intuitive control panel places essential functions within easy reach, making it straightforward to operate.

In addition to these features, the RP2167517BVE is compatible with various attachments, including baggers, mulchers, and snow blades, making it a multi-season workhorse for lawn and garden maintenance. The sturdy build of the mower is complemented by robust safety features, such as an automatic engine shut-off when the operator leaves the seat.

Another technological advantage of the Snapper RP2167517BVE is its tough construction, featuring a welded steel frame that stands up to rigorous use. The mower is also designed for easy maintenance, with access points that allow for quick cleaning of the deck and adjustments.

Overall, the Snapper RP2167517BVE combines power, comfort, and advanced technology to provide a superior mowing experience. Whether tending to a sprawling lawn or navigating tight spaces, this riding mower delivers performance and reliability that meet the demands of any homeowner.
Top Page Image Contents