Snapper P216019KWV, P217019BVE, P2167519B important safety instructions Operation

Page 3

IMPORTANT SAFETY INSTRUCTIONS

SAFE HANDLING OF GASOLINE

(Continued From Previous Page)

3.DO NOT remove fuel cap or add fuel with the engine running. Allow the engine to cool before refueling.

4.DO NOT refuel the machine indoors.

5.DO NOT store the machine or fuel container inside where there is an open flame, spark or pilot light such as on a water heater or other appliances.

6.DO NOT fill fuel containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place the containers on the ground away from the vehicle before filling.

7.Remove gas-powered equipment from the vehicle or trailer and refuel it on the ground. If this is not possible, then refuel equipment using a portable container, rather than a gasoline dispenser nozzle.

8.DO NOT start gas powered equipment in enclosed vehicles or trailers.

9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle lock-open device

10.If fuel is spilled on clothing, change clothing immediately.

11.DO NOT overfill a fuel tank. Replace fuel cap and tighten securely.

OPERATION

(Continued From Previous Column)

11.Before cleaning, repairing or inspecting make certain engine, blade and all moving parts have STOPPED. Disconnect and secure spark plug wire away from plug to prevent accidental starting.

12.STOP engine and wait until the blade comes to complete STOP before removing grass bag and/or clearing grass.

13.DO NOT operate mower without the entire grass catcher, discharge guard, rear guard or other safety devices in place and working. DO NOT point

discharge at people, passing cars, windows or doors.

14.DO NOT discharge material against a wall or obstruction. Material may ricochet back towards the operator.

15.Slow down before turning.

16.Watch out for traffic when near or crossing roadways.

17.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

18.Only use accessories approved by the manufacturer. See manufacturer's instructions for

proper operation and installation of accessories.

OPERATION

1.DO NOT put hands or feet near or under rotating parts. Keep clear of discharge area while engine is running.

2.STOP engine when crossing gravel drives, walks, or roads, and under any conditions where thrown objects might be a hazard.

3.Mow only in daylight or good artificial light.

4.DO NOT operate mower while under the influence of alcohol or drugs.

5.After striking a foreign object or if mower vibrates abnormally, STOP the engine, disconnect and secure spark plug wire. Inspect the mower for any damage and repair the damage before starting.

6.DO NOT mow near drop offs, ditches or

embankments. Operator could lose footing or balance.

7.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

8.DO NOT mow on wet grass. Always be sure of your footing. Keep a firm hold on the handle and walk, never run. Slipping could cause injury.

9.ALWAYS stay behind handle when engine (motor) is running.

10.DO NOT leave the machine with the engine running. STOP BLADE and STOP ENGINE before leaving the operators position for any reason.

MAINTENANCE AND STORAGE

1.DO NOT store mower or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before

storing machine in an enclosure. Store fuel container out of reach of children in a well

ventilated, unoccupied building.

2.Keep mower and engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Keep all bolts, especially blade bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

5.Always provide adequate ventilation when running engine. Engine exhaust gases contain carbon monoxide, a deadly poison.

6.Service engine and make adjustments only when engine is stopped. Removed spark plug wire from spark plug and secure wire away from spark plug to prevent accidental starting.

7.DO NOT change engine governor speed settings or overspeed engine.

8.Check grass bag assembly frequently for wear or deterioration to avoid thrown objects and exposure to moving parts. Replace with new bag if loose seams or tears are evident. Replace slider or bag adapter if broken or cracked.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Model Number Explanation Steel Deck Walk Mowers SeriesImportant Safety Instructions Operation Usage Statement Table of Contents Briggs Engine Speed Control Kawasaki Engine Speed ControlIntroduction Nomenclature PRE-START Check List Starting & OperationEngine & Blade Briggs Engine Stopping Handle Height AdjustmentCutting Height Adjustment Propelling Mower10a Installation of Grass BAG AdapterRemoving and Dumping Grass Catcher Slide Closure Type Installation of Grass CatcherRecycling Operation Service After First 5 Hours 3.2.1. Change Engine OIL IntroductionCheck Grease Level in Transmission Check Mower Blade Storage ProcedureSERVICE-ANNUALLY InjuryMower Blade Replacement Standard Blade Wear Limit Repair & AdjustmentsWheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementOn Next Replacing Rubber Driven Disc From PreviousInstall NEW Driven Disc Remove On Next Replacement Of Bearing On Pulley End Hex ShaftBelt Service Engine Drive Belt Replacement Stretch Type BeltsPulley Position Transmission Poly-V Belt ReplacementSyringe Hydrometer Digital Voltmeter Battery Service NEW Battery PreparationBattery Service Battery TestingCorrective Action TroubleshootingService Performed Each USE HRS MAINTENANCE/REPLACEMENT PartsHRS HRS HRS Season Disclaimer of Warranty Year Limited WarrantyIllustration Engine & how Can protect Itv Result In hard starting Create smoke from unburn PmduPrimary Maintenance Starting Check UST Snapper Product Registration Form Page Page GA., 30253 U.S,A Steel Deck Walk Behind Mowers Series

P216019KWV, P217019BV, P2167519B, P217019BVE specifications

The Snapper P217019BVE, P216019KWV, P217019BV, and P2167519B are a selection of high-performance lawn mowers designed to meet the needs of both residential and commercial users. These models are characterized by their durability, innovative features, and user-friendly designs, making them suitable for a variety of lawn care tasks.

One of the key features of these Snapper mowers is their powerful Briggs & Stratton engines. These engines are known for their reliability and efficient performance, providing ample power to tackle tough grass conditions. The P217019BVE and P217019BV feature a self-propelled drive system, allowing users to navigate uneven terrain with ease. This attribute significantly reduces the physical effort required by the operator, making lawn maintenance less of a chore.

The cutting deck design is another highlight of these models. Snapper has engineered these mowers with a 21-inch steel cutting deck that ensures a clean and precise cut. Additionally, users can easily adjust the cutting height, allowing for customization based on grass types and desired lawn aesthetics. The mulching capability enhances versatility, enabling users to recycle grass clippings back into the lawn for added nutrients.

The Snapper P216019KWV, with its innovative technology, boasts an electric start feature, eliminating the hassle of pull-starting. This convenience is particularly appreciated by those who may struggle with traditional starting methods. Furthermore, all models are designed with easy-to-use controls, ensuring a comfortable mowing experience for users of all skill levels.

Durability is another essential characteristic of Snapper mowers. With rust-resistant materials and reinforced construction, these machines are built to withstand the rigors of frequent use. The P2167519B also features large rear wheels that enhance stability and maneuverability, making it easy to navigate through tight spaces or uneven landscapes.

In summary, the Snapper P217019BVE, P216019KWV, P217019BV, and P2167519B models stand out for their powerful engines, self-propelled systems, adjustable cutting decks, and user-friendly features. Designed for both performance and durability, these mowers are perfect for anyone looking to maintain a beautifully manicured lawn with ease and efficiency, providing excellent value in the realm of outdoor power equipment.
Top Page Image Contents